Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Bolt spacing minimum

Number of bolts required, at minimum recommended bolt spacing... [Pg.854]

Step 3 Check the minimum bolt spacing (not an ASME requirement). Compare with the value of in Table 2-.5a. [Pg.39]

Bolt Size Standard Thread 8-Thread Series Boit Spacing Minimum Radiai Distance, R Edge Distance, E Nut Dimension, width across fiats. Waf Max Fiiiet Radius at base of hub, r Nut Stop, Ri... [Pg.147]

Maximum bolt spacing is 2a - - t. For minimum bolt spacing see Table 3-3... [Pg.148]

The wrench clearances limit the minimum bolt distance from the hub. In general it b desirable to use a minimum-dbmeter bolt circle and an even number of bolts, preferably a multiple of four. The minimum diameter of a bolt circle may be determined by setting up a table in which the number of bolts rei uired, the root area, the preferred bolt spacing, Bg, and the radial spacmig, R, are tabulated as functions of bolt size (see Table 10.4 for rot>t a Bg, and 1). The... [Pg.227]

Example 10.7. Suppose a vessel requires 24-2 -in. diameter bolts on a flange that is 5.5 in. thick. What is the maximum bolt circle that will not cause secondary bending stresses The minimum bolt spacing for 2 -in. diameter bolts is 5 m. [Pg.514]

If more anchor bolts are required than spacing allows, the sldrt may be angled to provide a larger bolt circle or bolts may be used inside and outside of the skirt. Ai c spacing should be kept to a minimum if possible. [Pg.200]

If Nb At is negative, then anchor bolts are not required. Use minimum size and maximum spacing for this case. [Pg.252]

Minimum spacing of anchor bolts is based on the maximum quantity of anchor bolts 4. Maximum spacing is based on 6 max arc spacing as practical limit. ... [Pg.294]

The minimum spacing for the wrench to fit 1 j-in. diameter bolts is 3 j in. Twelve bolts are to be used on a bolt circle of 15 5-in. diameter. WOiat is the minimum flange thickness that does not cause secondary flange bending ... [Pg.158]

In addition to these recommendations the Engineer shall comply with ACI 318 Section D.8. If the bolts are to be torqued, the minimum edge distances and spacings will increase. [Pg.30]

See other pages where Bolt spacing minimum is mentioned: [Pg.418]    [Pg.144]    [Pg.144]    [Pg.534]    [Pg.227]    [Pg.395]    [Pg.117]    [Pg.292]   
See also in sourсe #XX -- [ Pg.144 ]



SEARCH



Bolting

Bolts

© 2024 chempedia.info