Ball-mill temperature

Lead Monoxide. Lead monoxide (litharge), PbO, occurs as a reddish alpha form, which is stable up to 489°C where it transforms to a yellow beta form (massicot). The latter is stable at high temperatures. The solubihty of a-PbO ia water is 0.0504 g/L at 25°C the solubihty of the p-PbO is 0.1065 g/L at 25°C (40). Lead monoxide is amphoteric and dissolves ia both acids and alkahes. In alkahes, it forms the plumbite ion PbO - The monoxide is produced commercially by the reaction of molten lead with air or oxygen ia a furnace. Black or gray oxide is manufactured by the Barton process, by the oxidation of atomized molten lead ia air, as well as by the ball mill process, ia which metallic lead balls of high purity are tumbled ia the mill to form partially oxidized lead particles. 

Silicon Nitride. SiUcon nitride is manufactured either as a powder as a precursor for the production of hot-pressed parts or as self-bonded, reaction-sintered, siUcon nitride parts. a-SiUcon nitride, used in the manufacture of Si N intended for hot pressing, can be obtained by nitriding Si powder in an atmosphere of H2, N2, and NH. Reaction conditions, eg, temperature, time, and atmosphere, have to be controlled closely. Special additions, such as Fe202 to the precursor material, act as catalysts for the formation of predorninately a-Si N. SiUcon nitride is ball-milled to a very fine powder and is purified by acid leaching. SiUcon nitride can be hot pressed to full density by adding 1—5% MgO. 

In Benning el al. (146) some data on the kinetics of ethylene polymerization in the presence of TiCl2 activated by ball-milling are given. Polymerization was studied at 140-260°C (the solution process in cyclohexane). The first orders of the polymerization rate on the monomer and catalyst concentrations have been established. The polymerization decreased with temperature a sharp drop in rates at about 180-200°C was observed. 

By adhering to these conditions, Kaupp and coworkers performed a remarkable one-pot synthesis of highly substituted pyrroles [21]. When primary or secondary enamine esters 10-58 were ground with trans- 1,2-dibenzoylethene 10-59 in a ball-mill, the pyrroles 10-60 were obtained in quantitative yield (Scheme 10.15). In contrast, when in solution the yields were much lower and the reaction also required higher reaction temperatures. 

P.O.36 is completely fast to overcoating. Bleeding into a white overcoat is only observed at baking temperatures above 160°C. P.O.36 is heat stable up to 160°C. In dispersing the opaque type, it is important to avoid excessive shearing forces and to closely monitor the temperature, especially if agitated ball mills are used. Faulty temperature control may lead to a dull color. 

The S-form can be obtained by treating Copper Phthalocyanine Blue in benzene or toluene with aqueous sulfuric acid in the presence of a surfactant [21], The e-phase is produced by comminution of the a-, 7-, or 8-modification, for instance in a planetary ball mill. The mill base is then aftertreated in an organic solvent at elevated temperature. It is important to realize that the temperature, depending on the solvent, must be kept below the transition temperature at which the e-phase converts to the (3-modification (30 to 160°C). The e-modification is made best from the 7-phase, and the most preferred solvents are alcohols [22], For the industrially hitherto insignificant tt, X, and R-forms of Copper Phthalocyanine Blue (see [1], Vol. II, 34-35). 

---