Automated immersion testing

The use of the surface ultrasonic waves seems to be convenient for these purposes. However, this method has not found wide practical application. Peculiarities of excitation, propagation and registration of surface waves created before these time great difficulties for their application in automatic systems of duality testing. It is connected with the fact that the surface waves are weakened by soil on the surface itself In addition, the methods of testing by the surface waves do not yield to automation due to the difficulties of creation of the acoustic contact. In particular, a flow of contact liquid out of the zone of an acoustic line, presence of immersion liquid, availability of chink interval leads to the adsorption and reflection of waves on tlie front meniscus of a contact layer. The liquid for the acoustic contact must be located only in the places of contact, otherwise the influence on the amplitude will be uncontrolled. This phenomenon distorts the results of testing procedure. 

Through the use of lab tests implemented by the pulp and paper companies in the United States and Canada it was determined that all but one manual technique were both unrepeatable and inaccurate. During some years ago the operators of black liquor recovery boilers have been able to take advantage of the latest teehnology to inspect the wall thickness of the near drum generator tubes. The technology utilises immersion ultrasound and automated computer... 

In the pharmaceutical industry, it is important that aU products are properly tested and vahdated prior to release for sale. One of the most important tests is the determination of tablet dissolution rate. In this procedure tablets are immersed in a suitable medium to mimic the action of the stomach and the release of the active ingredients monitored over a period of time. Automation of these procedures is obviously important for various reasons including cost, accuracy of analysis and for validation of the results according to good laboratory practice. 

The printed circuit boards and the various electronic components to be added to it are cleaned, trimmed and sorted. The components are then mounted on to the printed circuit board ( stuffing ). This can be done either by hand or by automated surface mount machines. The parts are then soldered on to the board, by immersion in wave solder baths, or by hand. Excess solder and wire is removed by hand in a touching-up process. The final product is marked and tested in a quality control check. 

---