Autoignition temperature organic

Direct-Flame Incinerators. In direct-flame incineration, the waste gases are heated in a fuel-fired refractory-lined chamber to the autoignition temperature where oxidation occurs with or without a visible flame. A fuel flame aids mixing and ignition. Excess oxygen is required, because incomplete oxidation produces aldehydes, organic acids, carbon monoxide, carbon soot, and other undesirable materials. 

Benzyl chloride [(chloromethyl)henzene, a-chlorotoluene], CgH CH2Cl, is a colorless Hquid with a very pungent odor. Its vapors are irritating to the eyes and mucous membranes, and it is classified as a powerfljl lacrimator. The physical properties of pure benzyl chloride are given in Table 2 (2—7). Benzyl chloride is insoluble in cold water, but decomposes slowly in hot water to benzyl alcohol. It is miscible in all proportions at room temperature with most organic solvents. The flash point of benzyl chloride is 67°C (closed cup) 74°C (open cup) autoignition temperature is 585°C lower flammability limit 1.1% by volume in air. Its volume coefficient of expansion is 9.72 x. ... 

Benzotricbloride [(tricblorometbyl)benzene, a,a,a-trichlorotoluene, phenylchloroform], C H CCl, is a colorless, oily Hquid with a pungent odor. It is soluble in most organic solvents, but it reacts with water and alcohol. For ben zotricbl oride the flash point is 127°C (Cleveland open cup) and the autoignition temperature is 211°C (8). 

Flash points, lower and upper flammability limits, and autoignition temperatures are the three properties used to indicate safe operating limits of temperature when processing organic materials. Prediction methods are somewhat erratic, but, together with comparisons with reliable experimental values for families or similar compounds, they are valuable in setting a conservative value for each of the properties. The DIPPR compilation includes evaluated values for over 1000 common organics. Detailed examples of most of the methods discussed are available in Danner and Daubert."... 

Hilado. C. J. and Clark, S. W, Autoignition Temperatures of Organic Chemicals, Chemical Engineering, September 4, 1972, p. 75. 

By far the most important sulfide is CS2, a colourless, volatile, flammable liquid (mp — 111.6°, bp 46.25°, flash point —30°, autoignition temperature 100°, explosion limits in air 1.25 50%). Impure samples have a fetid almost nauseating stench due to organic impurities but the purified liquid has a rather pleasant ethereal smell it is very poisonous and can have disastrous effects on the nervous system and brain. CSt was formerly manufactured by direct reaction of S vapour and coke in He or steel retorts at 750 1000°C but, since the early 1950s, the preferred synthesis has been the catalysed reaction between sulfur and natural gas ... 

Autoignition Temperatures of Organic and Inorganic Powders in Air was determined by D.Costa et al, Chimica e Industria(Milano),... 

Flash points, lower and upper flammability limits, and autoignition temperature are important properties for determining safe operating limits when processing organic componnds. As with any property, experimental valnes are preferable to predicted values, and prediction techniques for these properties are only modestly accurate. 

TABLE 2-363 Group Contributions for Pintar Autoignition Temperature Method for Organic Compounds... 

Mitchell, B.E. and Jurs, P.C. (1997) Prediction of autoignition temperatures of organic compounds... 

AMINODIFENIL (Spanish) (92-67-1) Combustible liquid (flash point unknown autoignition temperature 842°F/4. iO°C). An organic base. Violent reaction with strong acids,... 

---