Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Alloy evaluation

Localized corrosion susceptibility of the alloys evaluated by ASTM G-48 test protocol and a test medium known as Green Death solution is detailed in Tables 4.43 and 4.44, respectively. The superior performance of Alloy 59 and C276 is obvious from the data on localized corrosion. [Pg.250]

ISO 11463 1995. Corrosion of metals and alloys - Evaluation of pitting corrosion. Geneva, ISO Copyright Office, 1995. [Pg.80]

The compositions of the alloys evaluated in Phase I are summarized in Table III. These alloys represent most classes of high-temperature iron-, nickel-, and cobalt-base alloys that could be considered for coal gasification service. Pack aluminized and chromized coatings on AISI 310 and IN-800 were also evaluated in the test program. [Pg.393]

Effect of oxidizer concentration on passivity Methods for Spontaneous Passivation of Metals Alloy Evaluation... [Pg.143]

Hypothetical alloys A, B, and C described in Fig. 4.17 are used to illustrate the alloy evaluation under reducing and oxidizing conditions. For reducing (or active state of the alloy) conditions (a), the alloy C is superior because of the lowest corrosion rates compared with the other two alloys in the active region. [Pg.676]

Chapter 4 presents the fundamentals of passivity the film and adsorption theories of passivity criterion for passivation methods for spontaneous passivation factors affecting passivation, such as the effect of solution velocity and acid concentration alloy evaluation anodic protection systems and design requirements. A fuU discussion on stainless steel composition and crystalline structure, oxidizer concentration, and alloy evaluation is included. The chapter also considers anodic protection to establish a basis for anodic... [Pg.780]

ISO 11463—Corrosion of Metals and Alloys— Evaluation of Pitting Corrosion... [Pg.375]

Paint/alloy evaluation (scribed line test)... [Pg.690]

Corrosion of metals and alloys—Evaluation of pitting corrosion... [Pg.858]

Corrosion of metals and alloys—Evaluation of stress corrosion cracking by the drop evaporation test Corrosion of metals and alloys—Corrosion in artificial atmosphere—Accelerated corrosion test involving exposure under controlled conditions of humidity cycling and intermittent spra5dng of salt solution... [Pg.858]

Takatsuka, K., Yamamuro, T, Nakamura, T, and Kokubo, T. (1995). Bone-bonding behavior of titanium alloy evaluated mechanically with detaching failure load. /. Biomed. Mater. Res. 29, 157-163. [Pg.672]

TABLE 10 Summary of Wave Solder Alloy Evaluations... [Pg.621]

TABLE 19 Lead-Free Alloys Evaluated in the JEIDA Project... [Pg.690]

See other pages where Alloy evaluation is mentioned: [Pg.280]    [Pg.165]    [Pg.141]    [Pg.690]    [Pg.690]    [Pg.690]    [Pg.690]    [Pg.690]    [Pg.690]    [Pg.690]    [Pg.86]    [Pg.132]    [Pg.288]    [Pg.304]   


SEARCH



Alloy evaluation anodic polarization curves

Alloy evaluation potentiostatic anodic polarization technique

Copper-zinc alloys stress-corrosion cracking evaluated using

© 2024 chempedia.info