Acylations trifluoromethanesulfonic acid

Friedel-Crafts acylation using nittiles (other than HCN) and HCI is an extension of the Gattermann reaction, and is called the Houben-Hoesch reaction (120—122). These reactions give ketones and are usually appHcable to only activated aromatics, such as phenols and phenoHc ethers. The protonated nittile, ie, the nitrilium ion, acts as the electrophilic species in these reactions. Nonactivated ben2ene can also be acylated with the nittiles under superacidic conditions 95% trifluoromethanesulfonic acid containing 5% SbF (Hg > —18) (119). A dicationic diprotonated nittile intermediate was suggested for these reactions, based on the fact that the reactions do not proceed under less acidic conditions. The significance of dicationic superelectrophiles in Friedel-Crafts reactions has been discussed (123,124). 

Esters of / fZ-amyl alcohol can be obtained by acylation of 2-methyl-2-butene in the presence of trifluoromethanesulfonic acid (44). The esters produced, in high yields, from reaction of amyl alcohols with carboxyHc anhydrides, are used as intermediates for preparation of pyryflum salts (45,46) and alkaloids (47). Tria2oles prepared by acylation of 3-methyl-1-butanol are useful as herbicides (48). 

Thus, the best compromises for Boc and Fmoc chemistries seem to be cyclohexyl and 2,4-dimethylpent-3-yl (Dmpn), which is of intermediate stability, and the removal of which by trifluoromethanesulfonic acid with the aid of thioanisole (see Section 6.22) leads to minimal imide formation (see Section 6.13). Points to note are that acidolysis of esters by hydrogen fluoride can lead to fission at the oxy-car-bonyl bond instead of the alkyl-oxy bond, thus generating acylium ions that can react with nucleophiles (see Sections 6.16 and 6.22), and that benzyl esters may undergo transesterification if left in methanol. The side reactions of cyclization (see Section 6.16) and acylation of anisole (see Section 6.22) caused by acylium ion formation do not occur at the side chain of aspartic acid.47-51... 

Aromatic hydrocarbons, Trifluoromethanesulfonic acid See Trifluoromethanesulfonic acid Acyl chlorides, etc. 

Trifluoromethanesulfonic acid, Acyl chlorides, Aromatic hydrocarbons, 0375 Trimethyl phosphate, 1318... 

Even an oligopeptide has been attached to (Table 4.3, compound 130) [111]. This was achieved by a coupling reaction of the carboxylic group in the side chain of the cyclopropane ring as well. First, the tert-butylcarboxylate 129 was synthesized by the reaction of the corresponding diazomethylbenzoate with Cgg. After hydrolysis with trifluoromethanesulfonic acid, the acyl chloride was generated by treatment with oxalyl chloride. Finally, in a one-step procedure the fullerene peptide 130 was obtained by the reaction with the N-deprotected pentapeptide H-(L-Ala-Aib)2-L-Ala-OMe. 

The acylation of dibenzofuran is carried out under the usual Friedel-Crafts conditions with an acid chloride or an acid anhydride in the presence of aluminum chloride. Dibenzofuran on treatment with 2-trifluoromethane-sulfonyloxypyridine and benzoic acid in boiling trifluoroacetic acid produces the 2-benzoyl derivative in 75% yield. The species responsible for benzoyla-tion is probably a mixed anhydride of trifluoromethanesulfonic acid and benzoic acid. Dibenzofuran on treatment with 2-benzoyloxypyridine and trifluoroacetic acid also produces the 2-benzoyl compound (21%). The kinetics of the acetylation of dibenzofuran with acetyl chloride and aluminum chloride in nitroethane at 25"C have been studied. Only the 2-acetyl compound was detected by the methods used. The rate obtained is in general agreement with the studies mentioned previously. The rate of acetylation of diphenyl ether relative to toluene was 138 (+ 16), whereas that of dibenzofuran was 5.9 ( 0.3). In contrast, the benzoylation of dibenzofuran with benzoyl chloride in the presence of aluminum chloride in nitrobenzene at... 

A review of solvent properties of, and organic reactivity in, ionic liquids demonstrates the relatively small number of quantitative studies of electrophilic aromatic substitution in these media.3 Studies mentioned in the review indicate conventional polar mechanisms. 1-Methylpyrrole reacts with acyl chlorides in the ionic liquid 1-butylpyridinium tetrafluoroborate to form the corresponding 2-acylpyrrole in the presence of a catalytic amount of ytterbium(III) trifluoromethanesulfonate.4 The ionic liquid-catalyst system is recyclable. Chloroindate(III) ionic liquids5 are catalytic media for the acylation, using acid chlorides and anhydrides, of naphthalene, benzene, and various substituted benzenes at 80-120 °C. Again the ionic liquid is recyclable. 

Preparation. The reagents are prepared in 80 100% yields by the reaction of the silver salt of trifluoromethanesulfonic acid with acyl halides ... 

The most important method for the preparation of aryl ketones is known as Friedel-Crafts acylation. The reaction is of wide scope. Reagents other than acyl halides can be used," including carboxylic acids," anhydrides, and ketenes. Oxalyl chloride has been used to give diaryl 1,2-diketones." Carboxylic esters usually give alkylation as the predominant product (see 11-11)." A-Carbamoyl p-lactams reacted with naphthalene in the presence of trifluoromethanesulfonic acid to give the keto-amide." ... 

More tractable and potentially useful polyether ketones, incorporating phenylene-carborane-phenylene units, and with properties suitable for high temperature applications, have been prepared by acylation reactions (using trifluoromethanesulfonic acid as both medium and catalyst) between appropriate dicarboxylic acids and phenoxyphenylcarboranes. For example, the polyetherketone 20 (Scheme 3.6), derived from bis(4-phenoxyphenyl)-para-carborane and biphenyl-4,4 -dicarboxylic acid, is essentially amorphous on isolation from trifluoromethanesulfonic acid, but crystallizes when heated above its glass transition temperature (267°C) before hnally melting at about 390 0... 

---