Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About
0 | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | a | b | c | d | e | f | g | h | i | j | k | l | m | n | o | p | q | r | s | t | u | v | w | x | y | z

   |<      <<      >>     > |    


I also lists the skeletal densities of the dried gels measured by helium pycnometry. The results do not follow a simple weighted average of the respective density of amorphous Si02 .

I also lists, again for the three best ab initio studies, the equilibrium dissociation energy , ground-state

I also presents the temperature at which this exothermal process starts . The difference Tg- T can be considered as being the processing window of the thermally reactive oligomers, and is also listed in Table I.

I also provides a comparison with the characteristics of sup-

I also shows rate constants for reactions of the sulfate radical ion. By preparing suitable aqueous solutions, it may also be possible to measure reaction rates of radicals like CH2OH, C02 , etc.

I also shows that kulmlA is approximately equal to 0.5 so that one can find a rough value for sifmlA is known. .

I also shows that the a data for the aromatic hydrocarbons become more negative on passing from OV-1 through OV-17, and fluctuate about -0.99 thereafter. That is, the retentions of benzene and toluene on passing from OV-1 to OV-25.

I also shows that the fluorescence lifetimes are significantly greater in the 820 nm band for isolated chlorosomes than for whole cells, although they do not approach levels expected on the basis of energy transfer efficiency. For example, the average lifetime of 820 nm emission is about 3 times greater for isolated chlorosomes of Chlorobium than for whole cells this would indicate a maximum transfer efficiency of 75 . Similar behavior is observed in Chloroflexus, where the average lifetime increases by only about a factor of 2 .

I also shows that the initiator and monomer concentration can also markedly affect the chain structure in nonpolar media . Thus, the highest cis-1,4 content in the case of both polybutadiene and polyisoprene is obtained in the absence of any solvents and at very low initiator levels.

I also shows that the main component of the total CO2 evolved, which is determined by GC, is the C02, and the total of the other CO2 isotopes is about 10 of C02. The low concentrations of the isotopic 8C02 and C02 are still, however, an easily measurable quantity of GC-mass spectrometer. The C02 is used as the standard, because the measurement of relates directly to the quantity of the abundant C02. Its low concentration levels help to improve the measuring accuracy of the other CO2 isotopes, chich are also in low concentration. The moles

I also shows that the mean lengths of the carbonyl-bridged Ni2-Ni3 bonds in the central Ni6 are virtually identical with those of the carbonyl-bridged Nii-Nii bonds. Each of these carbonyl-bridged Ni-Ni bonds is considered to correspond to a normal electron-pair bond.

I also shows that the modified kinetic analysis is applicable for conversions up to about 90 . Beyond 90 conversion, more complicated kinetic mehcanisms, as well as limitations in the experimental procedure, could limit the agreement between data and model.

I also shows that TMEDA has a much greater effect on the reactivity of butyllithium than does either triethylamine or N,N -dimethyl-piperazine. To explain this difference it is suggested that the reactive species contain two coordinated amine groups. The unusual reactivity with TMEDA is then related to the favorable entropy change usually

I also shows that when moisture is present during oven aging, the degradation rate is accelerated, pinner confirms this finding in a review article on the aging of paper .

I also shows the approximate amount of leaflike trash found in materials processed by the textile and nontextile cotton industries. Seed cotton at the gin contained about 2 contained 0.8 leaflike trash.

I also shows the nature of the organic remains, as far as this could be ascertained. If the interior surface of a shard, and especially of a body shard, was covered with a thin, continuous coating of resinous material, the sample was classified as a lining. If there was a substantial, compact deposit at the bottom or toe of the vessel but no coating on adjacent interior surfaces, the sample was classified as a residue. Eight samples could not be classified because the evidence was ambiguous. Two samples from rims may have been seals used to lute the cover of the vessel opening.

I also shows the same classification accuracy for both models. So, despite high standardized coefficients in the TM REE model, the REEs are not as useful for fingerprinting these mining regions as are Sc, Mn, and Cr.

I also shows two additional parameters, the anisotropy index . These indices give a quantitative measure of the molded part anisotropy and are defined as follows

I Alternative Choices for Panel Type, Panel Size and Sample Replication

I Ames Test for Mutagenicity of 13-Hydroperoxylinoleate

I Amino Acid Composition

I Amino Acid Composition of Bovine Elastins

I Amino acid composition of human cathepsin D

I Amino Acid Composition of Human Relaxin B-chain

I Amino Acid Composition of Peptide 1-16 and Its Guanidinated Derivative



   |<      <<      >>     > |    

SEARCH



© 2024 chempedia.info