Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About
0 | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | a | b | c | d | e | f | g | h | i | j | k | l | m | n | o | p | q | r | s | t | u | v | w | x | y | z

   |<      <<      >>     > |    


Typical timing behavior of the quadratic Fock matrix formation versus the cubically scaling diagonalization step , 1 — 16 are depicted. Integral threshold is 10 , basis set 6-31G.

Typical timing of material, engineering manhours, and construction.

Typical tip morphology obtained after high-temperature treatment .

Typical TIS spectrum of a cylindrical 18650 Li-ion battery.

Typical titration curve obtained for the system Cm-Aldrich humic acids by TRLIF 10 M, pH 4, NaC104 O.OOIM.

Typical titration curve of an acidic mine water. The inset shows the correlation between the acidity released during titration of waters from acidic mine pit lakes of the IPB to a target pH of 8.3 . Data taken from Refs. 14 and 45.

Typical titration curves

Typical titration curves for the case noted. Normalized production rate of HCN vs. flow rate of methane. Dashed lines of slope 1 3 and 2 3 are

Typical titration curves. The water curve indicates the amount of alkali needed to titrate the water, and the acid curve is a conventional titration curve. The difference curve is the horizontal difference between the acid and the water curve, and is the adjusted titration curve, e.g., point b is c—a. The pK is the point of inflection, which is also the point at where half of the acid is neutralized.

Typical Tj and T2 relaxation measurements of TGF-a. Relaxation data for the aromatic sidechain protons of residue Y38 are shown for TGF-a in the absence of EGFR-ED. Panels A, C and E depict Tj experimental data and panels B, D and F depict T2 data. In panels A B are plots of typical curve-fit data.

Typical TL curves of LiF TLD-100 ribbons .

Typical TLC chromatograms of cellulose triacetate solid lines

Typical TLC retention order on cellulose of anthocyanidins with respect to their B-ring substituents. See Table 4 for explanation of abbreviations. Upper. Aqueous solvents as mobile phase. This retention order is also observed for anthocyanin 3-0-monogIycosides. Lower. Alcoholic solvent as mobile phase.

Typical TLC retention order on cellulose of anthocyanidins with respect to their Bering substituents. See Table 4 for explanation of abbreviations. Upper. Aqueous solvents as mobile phase. This retention order is also observed for anthocyanin 3-O-nionoglycosides. Lower. Alcoholic solvent as mobile phase.

Typical TLE oudet temperatures as a function of time on stream for various feedstocks

Typical TLE outlet temperatures as a function of time on stream for various feedstocks

Typical tnnamittanceofPMT window materials. Revised from Ref. 14.

Typical tocopherol levels in deodorizer distillate obtained from crude oils based on .

Typical TOF-MRA

Typical toggle clamp unit. A

Typical ton container.

Typical toner particles.

Typical TOP spectra 20 is the scattering angle

Typical top surface images of Shipley SAL 605 negative-tone, chemically-amplified resist. The color bar at the left is representative of the peak-to-peak height difference in the images.

Typical torque curves for NEMA design B, C and D Induction motors having synchronous speeds below 1,800 rpm. These curves also apply to some 1,800 rpm design motors. Used by permission



   |<      <<      >>     > |    

SEARCH



© 2024 chempedia.info