Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About
0 | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | a | b | c | d | e | f | g | h | i | j | k | l | m | n | o | p | q | r | s | t | u | v | w | x | y | z

   |<      <<      >>     > |    


The specific surface area and the pore volume of silica gels versus the temperature of HTT for 2 h.

The specific surface area of plain and CaCI2 containing pastes as a function of hydration time .

The specific surface area of plain and CaCl2 containing pastes as a function of hydration time .

The specific surface area of silica gel containing 40 ppm of Na versus the temperature of heating under various atmospheres.

The specific surface area of silica gel containing various amounts of Na impurities versus the temperature of heating.

The specific surface area of various PB PS sequential IPN s is plotted vs. polystyrene conversion. The broad maximum near 50 conversion occurs near the composition where the morphology changes from one of cylinders to one of

The specific surface S due to the large specific surface of these systems.

The specific swelling of PS-b-PS DAP diblock copolymer using complementary Thy-Gx polyether dendron resulted in a series of morphologies

The specific tensile strength and modulus of various fibers

The specific volume

The specific volume in a liquid decreases more rapadly with temperature than the crystal. The thermal expansion coefficient of glass is similar to that of the crystal. The final specific volume of the glass depends on the cooling rate

The specific volume of filter cake, sediment volume and Bingham yield stress of sodium montmorillonite sols as a function of the NaCI concentration.

The specific volume of poly.

The specific volume offilter cake, sediment volume, and Bingham yield stress of sodium montmorillonite sols as a function of the NaCI concentration. From van Olphen , Copyright 1977, Wiley-lnterscience.

The specific volume v , the thermal expansion coefficient a is proportional to the slope dv dT. At low temperature, polyethylene is a hard crystalline plastic material. On melting at around 130 C, the specific volume v increases sharply and a is large. Source. JE Mark,

The specific wear rates of pins and discs under different loads for MSO or Si3N4 on bearing steel sliding ccmiacts with Mobil Jet II lubrication

The specific woiidng tensile strengths of various materials.

The specific-heat curve C.

The specific-volume-temperature cooling curves for the epoxy resin EPON lOOlF DDS fully cured at four different rates of cooling as indicated. The corresponding TgS identified by the intersection point of the equilibrium and glass lines are listed.

The specification for the checksum generator of

The specification tree

The specifications of rigorous VDU model are similar to ADU model

The specificities of members of the VEGF family for their receptors.

The specificity of binding of the fluorescent probe to the Ab-coated optic fibers of the biosensor, The fluorescence transmitted by TCPB-FL, bound to the fiber coated with rabbit anti-PCB IgGs, control rabbit IgG, human IgG or casein compared to a bare fiber. It is clear that the non-specific TCPB-FL binding to the quartz fibers, non-target IgG can be significant and must be corrected for. Reproduced with permission from references 4 and 27, Copyright 1995, American Chemical Society.

The specificity of pullulanase of a-1,6-glycosidic bond .



   |<      <<      >>     > |    

SEARCH



© 2024 chempedia.info