Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About
0 | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | a | b | c | d | e | f | g | h | i | j | k | l | m | n | o | p | q | r | s | t | u | v | w | x | y | z

   |<      <<      >>     > |    


IR photoluminescence spectra of

IR powder spectra for synthetic micas on the mnscovite-alnmoceladonite

IR powder spectra of synthetic members of the talc-Ni talc

IR powder spectra of synthetic micas along the tetrasilicic Mg-mica TMM

IR procedures to determine composition ratio, when sample has different microstructure from those of standards.

IR radiation by difference frequency generation in LiNbOa

IR ratio 1547 1512 cm lfor gluten

IR ratio 1547 1512 cm-1 as a function of temperature for gluten with different initial moisture content. From top to bottom

IR reflectance spectrum of 10 pm of PTFE on silicon.

IR reflection spectra from an ODS monolayer on silicon for s- and p-polarized radiation at different incident angles ft Symmetric , asym-

IR reflection spectra of a Li20-Si0i 33

IR reflection spectra of a simulated nuclear waste glass buried in a granite repository for 28 d at 90 C with SA V 1.0. Each spectrum corresponds to a different depth within the surface. The percent reflectance is obtained when all of the corroded surface layer is removed by polishing. Key to a IRRA-polish of

IR reflection spectroscopy.

IR reflection transmission spectra for InAs films formed on a smooth, annealed Au surface and on a roughened Au surface. The substrate was formed by taking a well annealed, smooth Au on glass substrate and vapor depositing more Au on one half, at room temperature, so that a series of 40 bumps were formed over one half of the surface. The two deposits were thus formed in the same electrodeposition run. Adapted from ref. ,

IR reflection transmission spectra for InAs films formed on smooth annealed Au surface and roughened Au surface. Substrate was formed by taking a well-annealed, smooth Au on glass substrate and vapor-depositing more Au on one half, at room temperature, so that a series of 40 bumps were formed over one half of the surface. The two deposits were subsequently formed in the same electrodeposition run.

IR reflection-absorption spectra for a PME slick at the air water interface after compression to 0.272 nm2 molecule and subsequent relaxation, from bottom to top after 10, 30, 50, and 80 min, respectively

IR reflection-absorption spectra, at 55 off-normal incidence, of a silica gel film dried at room temperature, taken with

IR reflectivity of the low-temperature

IR response to water contamination in engine oils

IR response to water contamination of a steam turbine oil

IR response to water contamination of polyol ester turbine oil

IR result for a white cement paste mixed at w c 0.40 and cured under water for 28 days at 20 C. The peak assignment is shown. Contrary to Tj results, the solid signal appears with the longest relaxation time T,.

IR results for benzaldehyde on alumina compared with lETS results for 4-hydroxybenzoic acid on alumina. A vertical shift has been imposed at 1300 cmr. Note the difference in intensity of the IR and lETS symmetric and antisymmetric stretch modes.

IR salt plates and holder.

IR salt plates and holder. From Zubric, James W. The Organic Chem Lab Survival Manual, 7th ed. Wfley



   |<      <<      >>     > |    

SEARCH



© 2024 chempedia.info