Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Versus injection-molded blends

The results of viscosity versus shear rate are reported in Fig. 11 for the two pure components and their blend, respectively. The temperatures were the same for the viscosity measurements and for the injection molding. At temperatures of 280°C and 320°C, the viscosities of the blend are found to be values between the limits of the two pure components. In both cases, the TLCP still... [Pg.692]

Figure 16.6 Skew of a wall of a divided tray, right after injection molding with glass fiber-reinforced SPS/nylon blends versus glass fiber-reinforced SPS and PBT. Figure 16.6 Skew of a wall of a divided tray, right after injection molding with glass fiber-reinforced SPS/nylon blends versus glass fiber-reinforced SPS and PBT.
Figure 4.41 Tensile stress amplitude versus cycles to failure for SABIC Innovative Plastics Geloy XP4025-weatherable, injection molding ABS/PC blend [6],... Figure 4.41 Tensile stress amplitude versus cycles to failure for SABIC Innovative Plastics Geloy XP4025-weatherable, injection molding ABS/PC blend [6],...
See other pages where Versus injection-molded blends is mentioned: [Pg.507]    [Pg.343]    [Pg.199]    [Pg.215]    [Pg.60]    [Pg.96]    [Pg.203]    [Pg.277]    [Pg.349]    [Pg.99]    [Pg.6208]   
See also in sourсe #XX -- [ Pg.310 , Pg.311 , Pg.312 ]



SEARCH



Injection-molded blends

Molding blending

© 2024 chempedia.info