Surges frequencies

Therefore, if the arc does not extinguish at the first current zero, it will give rise to voltage surges (TRVs) at very high surge frequencies... 

In this time the surge frequency will undergo... 

The value of L and C of a machine will determine its surge impedaiice = -jUC and surge frequency /, = LC). A low surge impedance will help to... 

A surge capacitor offers a near-open circuit during normal operation (at or near the power frequencies) and a near-short-circuit to the arriving surges at surge frequencies, while the inductance of the motor windings (<> will... 

A lightning surge and an FOW have more influence compared to a switching surge due to the former s higher surge frequencies,/j. 

A surge capacitor loo, when used in parallel to supplement such an arrester, will not be able to make the arrester suitable for such a duly. This is effective only against very steep surges having a very high surge frequency of lO kHz and more. The frequency of a surge can be determined by... 

Ii is seen ihai ihe surge frequency during current chopping may rarely exceed 20 kHz and which, in the context of switching. surges, may be considered as low-frequency oscillations, easy to handle and interrupt. 

Under transient conditions,/becomes surge frequency, and... 

This will be the surge frequency of the switching circuit when the sixth capacitor is switched on a circuit that has five capacitor units already switched. The improved value of this switching frequency, /s, af si the introduction of inductance 42.93 uH in each capacitor circuit will become. 

The dynamic compressors, axial and centrifugal, exhibit one other non-steady force, which is often questioned by foundation designers. This is the torque reaction force at the casing feet and, thus, the foundation due to surge. As a rule of thumb, a value of A the maximum steady-state torque reaction at the casing feet can be used. The frequency is the surge frequency, which is less than operating speed but not readily predictable, because it is heavily dependent on the connected system. 

This range of batteries is particularly suitable for any standby application calling for a good high-rate discharge characteristic. Such applications include electronic computer and telecommunications equipment, which requires a no-break clean power supply free from voltage surges, frequency variations and other transients. 

---