Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Static neutralizer

At present, when working with high-purity materials, smooth solid surfaces and low P02 atmospheres, the thermodynamic contact angle in a particular system can be determined at best within about five degrees. Roughness must be very low, particularly in non-wetting systems in order to obtain such an accuracy. The control of P02 is critical for oxidisable liquids and solids, specially at relatively low temperatures, and dynamic vacuum is often preferable to a static neutral gas atmosphere. [Pg.143]

When experiments are performed in a static neutral gas atmosphere, deoxidation depends on diffusion of volatile species into the gas. For the same temperature and P02 values, deoxidation takes longer in such atmospheres than in a high vacuum but some acceleration can be achieved by using dynamic conditions i.e., gas flow (Ricci et al. 1994). [Pg.238]

Negative Instruction Static Neutral Traasition Affect Rating ],nj,g4 Task... [Pg.244]

Magic Wand, Static neutralizers, Sticht, Herman H. [Pg.918]

Vinyzene, Antimicrobial, Morton International Inc., Morton Plastics Additives Viper, Static neutralizing blowoff gun, SIMCO Viplex (Series), Plasticizers, Crowley Chemical Co. [Pg.945]

Carrigan S D et al. (2003) Development of a Three-Dimensional Finite Element Model for Carpal Load Transmission in a Static Neutral Posture, Annals of Biomedical Engineering 31 718-725... [Pg.777]

Formal Theory A small neutral particle at equihbrium in a static elecdric field experiences a net force due to DEP that can be written as F = (p V)E, where p is the dipole moment vecdor and E is the external electric field. If the particle is a simple dielectric and is isotropically, linearly, and homogeneously polarizable, then the dipole moment can be written as p = ai E, where a is the (scalar) polarizability, V is the volume of the particle, and E is the external field. The force can then be written as ... [Pg.2011]

Static Secondary Ion Mass Spectrometry (SIMS) involves the bombardment of a sample with an energetic (typically 1-10 keV) beam of particles, which may be either ions or neutrals. As a result of the interaction of these primary particles with the sample, species are ejected that have become ionized. These ejected species, known as secondary ions, are the analytical signal in SIMS. [Pg.41]

Aqueous environments Neutral chloride solutions do not corrode titanium alloys at ambient temperatures, and smooth statically loaded specimens of susceptible alloys do not exhibit failure. In order to nucleate cracking it appears probable that the protective oxide film on alloys must be destroyed and its repair must not occur. If this breakdown occurs then cracking is observed in susceptible alloys. Consequently, the type of test and the type of specimen employed in any selected test are both important considerations, particularly in alloys exhibiting low susceptibility. [Pg.1262]

Conditioners are surfactants that neutralize the electrical charge on the surface of the hair, and smooth down protein scales on the hair shafts. These effects make the hair easier to style and less prone to static electricity. [Pg.219]

Since stretch affects the onset of flame pulsation, it should correspondingly affect the state of extinction in the pulsating mode. We shall therefore assess the influence of stretch in modifying the state of extinction. If the extinction turning point of a steady-flame response curve is neutrally stable, the entire upper branch should be dynamically stable then, the corresponding static-extinction stretch rate is the physical limit. [Pg.123]

Both of the control schemes for the neutralizer took measurements on the major varying streams before they were diluted in the large blending tank. This is usually desirable because once the streams are mixed the measurable differences are smaller, and the possibility of noise (the equivalent of static in radio signals) affecting the measurement accuracy is greater. [Pg.172]

Explodes violently on heating above 240°C [1]. A I4g sample exploded while being transferred to a cold, empty, unagitated flask via a polythene powder funnel, injuring the worker. The isolated salt was essentially neutral, so excess periodic acid cannot be involved. Subsequent attempts to explode the material deliberately have failed, but it is felt that static electricity may be the cause [2], [3],... [Pg.578]


See other pages where Static neutralizer is mentioned: [Pg.2334]    [Pg.55]    [Pg.77]    [Pg.23]    [Pg.230]    [Pg.80]    [Pg.101]    [Pg.2089]    [Pg.2525]    [Pg.2505]    [Pg.2338]    [Pg.511]    [Pg.511]    [Pg.898]    [Pg.102]    [Pg.2334]    [Pg.55]    [Pg.77]    [Pg.23]    [Pg.230]    [Pg.80]    [Pg.101]    [Pg.2089]    [Pg.2525]    [Pg.2505]    [Pg.2338]    [Pg.511]    [Pg.511]    [Pg.898]    [Pg.102]    [Pg.2472]    [Pg.287]    [Pg.289]    [Pg.289]    [Pg.89]    [Pg.159]    [Pg.529]    [Pg.550]    [Pg.181]    [Pg.245]    [Pg.582]    [Pg.64]    [Pg.191]    [Pg.367]    [Pg.169]    [Pg.199]    [Pg.245]    [Pg.317]    [Pg.213]    [Pg.176]    [Pg.35]   
See also in sourсe #XX -- [ Pg.511 ]




SEARCH



© 2024 chempedia.info