Sisko viscosity model

As discussed in Chapter 3, the Carreau viscosity model is one of the most general and useful and reduces to many of the common two-parameter models (power law, Ellis, Sisko, Bingham, etc.) as special cases. This model can be written as... 

The power law model can be extended by including the yield value r — Tq = / 7 , which is called the Herschel-BulMey model, or by adding the Newtonian limiting viscosity,. The latter is done in the Sisko model, 77 +. These two models, along with the Newtonian, Bingham, and Casson... 

If r/0 (i], 1] ) and (ky)2 >S> 1, the Carreau model reduces to the equivalent of a power law model with a high shear limiting viscosity, called the Sisko model ... 

If some or all of this curve is present, the models used to fit the data are more complex and are of two types. The first of these is the Carreau-Yasuda model, in which the viscosity at a given point (T ) as well as the zero-shear and infinite-shear viscosities are represented. A Power Law index (mi) is also present, but is not the same value as n in the linear Power Law model. A second type of model is the Cross model, which has essentially the same parameters, but can be broken down into submodels to fit partial data. If the zero-shear region and the power law region are present, then the Williamson model can be used. If the infinite shear plateau and the power law region are present, then the Sisko model can be used. Sometimes the central power law region is all that is available, and so the Power Law model is applied (Figure H. 1.1.5). 

Basic Protocol 2 is for time-dependent non-Newtonian fluids. This type of test is typically only compatible with rheometers that have steady-state conditions built into the control software. This test is known as an equilibrium flow test and may be performed as a function of shear rate or shear stress. If controlled shear stress is used, the zero-shear viscosity may be seen as a clear plateau in the data. If controlled shear rate is used, this zone may not be clearly delineated. Logarithmic plots of viscosity versus shear rate are typically presented, and the Cross or Carreau-Yasuda models are used to fit the data. If a partial flow curve is generated, then subset models such as the Williamson, Sisko, or Power Law models are used (unithi.i). 

The power law does not describe the regions of the viscosity curve near y = 0 and y —> oo. To this end, the Ellis model at low shear rates and the Sisko model at high shear rates can be used (2). The models are given by... 

---