Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Sensitizers substitution reactions

The range of preparatively useful electrophilic substitution reactions is often limited by the acid sensitivity of the substrates. Whereas thiophene can be successfully sulfonated in 95% sulfuric acid at room temperature, such strongly acidic conditions cannot be used for the sulfonation of furan or pyrrole. Attempts to nitrate thiophene, furan or pyrrole under conditions used to nitrate benzene and its derivatives invariably result in failure. In the... [Pg.45]

The introduction of halogen into organic molecules can be carried out by a variety of addition or substitution reactions. The classical methods for the addition of halogen to double bonds or the substitution of halogen for hydroxyl by hydrohalic acids are too well known to bear repetition here. Discussed below, then, are methods that are of interest because of their stereospecific outcome or because they may be used on sensitive substrates. [Pg.45]

Though thermally stable, rhodium ammines are light sensitive and irradiation of such a complex at the frequency of a ligand-field absorption band causes substitution reactions to occur (Figure 2.47) [97]. The charge-transfer transitions occur at much higher energy, so that redox reactions do not compete. [Pg.120]

In anionic and coordination polymerizations, reaction conditions can be chosen to yield polymers of specific microstructurc. However, in radical polymerization while some sensitivity to reaction conditions has been reported, the product is typically a mixture of microstructures in which 1,4-addition is favored. Substitution at the 2-position (e.g. isoprene or chloroprene - Section 4.3.2.2) favors 1,4-addition and is attributed to the influence of steric factors. The reaction temperature does not affect the ratio of 1,2 1,4-addition but does influence the configuration of the double bond formed in 1,4-addition. Lower reaction temperatures favor tram-I,4-addition (Sections 4.3.2.1 and 4.3.2.2). [Pg.183]

Since thiophene derivatives, heterocyclic aromatic compounds, are sensitive toward electrophilic substitution reactions, the bromination of these compounds generally gives a mixture of mono-, di-, and other poly-substituted bromination products (ref. 19). However, we have recently found that BTMA Br3 is a useful... [Pg.36]

In a ligand substitution reaction, two groups must always receive attention. There is a bond to the leaving group to be broken and a bond to the entering group to be formed. The relative importance of these two processes provides a basic dichotomy for the classification of substitutions. If a reaction rate is sensitive to... [Pg.2]

The difference in position of attack on primary and secondary aromatic amines, compared with phenols, probably reflects the relative electron-density of the various positions in the former compounds exerting the controlling influence for, in contrast to a number of other aromatic electrophilic substitution reactions, diazo coupling is sensitive to relatively small differences in electron density (reflecting the rather low ability as an electrophile of PhN2 ). Similar differences in electron-density do of course occur in phenols but here control over the position of attack is exerted more by the relative strengths of the bonds formed in the two products in the two alternative coupled products derivable from amines, this latter difference is much less marked. [Pg.148]

When polymerizing A2B monomers there is a possibihty of losing the unique focal point due to intramolecular cyclization. The loss of the focal point in a hyperbranched polyester based on 4,4-(4 -hydroxyphenyl)pentanoic (Fig. 7) acid was closely examined by Hawker et al. [45]. The study showed no significant occurrence of intramolecular cyclization. One disadvantage of polycondensation polymers is that they are sensitive to hydrolysis, that is depolymerization, which might restrict their use. Some hyperbranched polymers are synthesized via substitution reactions which provide less hydrolytically unstable polymers. [Pg.8]

We have examined the competing isomerization and solvolysis reactions of 1-4-(methylphenyl)ethyl pentafluorobenzoate with two goals in mind (1) We wanted to use the increased sensitivity of modern analytical methods to extend oxygen-18 scrambling studies to mostly aqueous solutions, where we have obtained extensive data for nucleophilic substitution reactions of 1-phenylethyl derivatives. (2) We were interested in comparing the first-order rate constant for internal return of a carbocation-carboxylate anion pair with the corresponding second-order rate constant for the bimolecular combination of the same carbocation with a carboxylate anion, in order to examine the effect of aqueous solvation of free carboxylate anions on their reactivity toward addition to carbocations. [Pg.327]

The scope of reactions catalyzed by metalacychc iridium-phosphoramidite complexes is remarkably broad, but reactions with some substrates, such as allylic alcohols, prochiral nucleophiles, branched allylic esters, and highly substituted allylic esters, that would form synthetically valuable products or would lead to simpler symthesis of reactants occur with low yields and selectivities. In addition, iridium-catalyzed allylic substitution reactions are sensitive to air and water and must be conducted with dry solvents under an inert atmosphere. Several advances have helped to overcome some, but not aU of these challenges. [Pg.201]

Except for one recent example, all iridium-catalyzed allylic substitution reactions have been performed under an inert atmosphere with dry solvent and reagents. The iridium metalacycle is sensitive to protonation, which opens the metalacycle and results in the formation of a less-active complex containing a K -phosphoramidite ligand. A paper by Helmchen et al. addressed this issue [107]. Nearly all iridium catalysts used for allylic substitution consist of an iridium fragment chelated by COD. In the presence of a catalyst containing dibenzo[a,c]cyclooctatetraene (dbcot) in place of COD, allylic substimtion reactions occur in air with results that are comparable to those of reactions performed under an inert atmosphere (Scheme 35). [Pg.205]

Direct reaction of iron pentacarbonyl with trimethylsilyl isocyanide ( C=N—SiMe3) at 65°-75° yields an air-sensitive substitution product Me3Si—N=C Fe(CO)4 in 93% yield, with elimination of carbon monoxide (152). It was shown by infrared spectroscopy (38) that complex formation lowers the N=C bond order for Me3Si—N=C , whereas it raises the N=C bond order for Me3C—N=C , presumably as a result of interaction between dv orbitals of silicon with the metal d orbitals. [Pg.119]

Syntheses of Polymeric Photosensitizers and Self-sensitized Polymers by the Reactions of PCVE. Photosensitizer monomers such as NPVE, NNVE and NPEVE were synthesized by the reaction of excess CVE with potassium salts of the corresponding photosensitizing compounds using TBAB as a phase transfer catalyst as described in the experimental part. Substitution reactions of chloroethyl groups in PCVE with PNP and PNN were also carried out using TBAB as a phase transfer catalyst in DMF at 80 C for 24 h. [Pg.230]


See other pages where Sensitizers substitution reactions is mentioned: [Pg.558]    [Pg.266]    [Pg.2]    [Pg.298]    [Pg.187]    [Pg.134]    [Pg.156]    [Pg.221]    [Pg.200]    [Pg.165]    [Pg.213]    [Pg.38]    [Pg.584]    [Pg.319]    [Pg.630]    [Pg.172]    [Pg.5]    [Pg.260]    [Pg.69]    [Pg.128]    [Pg.34]    [Pg.125]    [Pg.193]    [Pg.176]    [Pg.211]    [Pg.334]    [Pg.412]    [Pg.125]    [Pg.596]    [Pg.80]    [Pg.248]    [Pg.335]    [Pg.167]    [Pg.55]    [Pg.268]   
See also in sourсe #XX -- [ Pg.5 , Pg.492 ]




SEARCH



Reactions sensitivities

Sensitization reactions

Sensitizers reactions

© 2024 chempedia.info