Section trajectory bundles extractive-column

The general approach to design calculation of extractive distillation columns is similar to the approach applied for two-section columns. We use our notions about the structure of intermediate section trajectory bundles (see Sections 6.4 6.6), about possible compositions at the trays adjacent to the feed cross-section from above and below (see Section 7.2), and about possible directions of calculation... 

Let s examine now the structure of trajectory bundles of sharp reversible distillation for the intermediate (extractive) section of the column with two feedings at separation of different types of azeotropic mixtures, the way we did it for the top and the bottom sections (Fig. 4.21). While composing these diagrams, we used, just as we did before, the data on the phase equilibrium coefficients of present and absent components at the sides of the concentration triangle and the general regularities of the location of the trajectory bundles of sharp reversible distillation. 

We have a considerable limitation of sharp extractive distillation process in the column with two feeds the process is feasible if the top product components number is equal to one or two. This Umitation arises because, in the boundary element formed by the components of the top product and the entrainer, there is only one point, namely, point iV+, that belongs to the trajectory bundle of the intermediate section. If Eq. (6.11) is valid, then the joining of the trajectories of the intermediate and top sections takes place as at direct split in two-section columns in the mode of minimum reflux. If Eq. (6.12) is valid then joining goes on as at split with one distributed component. 

The location of intermediate sections trajectories of columns with two feeds, including those at extractive, heteroazeotropic, and heteroextractive distillation, has fundamental distinctions from that of section trajectories of the simple columns. At sharp extractive or heteroextractive distillation, pseudoproduct point x), of the intermediate section should be located at the continuation of the boundary element, to which components of top product and of entrainer belong. If this condition is valid, the whole trajectory bundle of the intermediate section including trajectory tear-off point x[ from the mentioned boundary element is located in the region Reg where the top product components are more volatile and the entrainer components are less volatile than the rest of components. The trajectory tear-off point of the intermediate section is the stable node x[ = A+). The conditions of intermediate section trajectory tear-off in different points of trajectory tear-off region Reg allow to determine limit modes of extractive distillation for each mixture - the mode of minimum flow rate of the entrainer min, and for the... 

---

See also in sourсe #XX -- [ , , , , , ]

---