Reboilers reboiler Natural thermosyphon

I worked as a process design engineer for Amoco Oil in Chicago until 1980. Likely, I designed about 50 distillation columns, 90 percent of which had horizontal, natural thermosyphon circulation reboilers. 

In a thermosyphon or natural-circulation reboiler, there is, of course, no source of air. The aerated liquid is a froth or foam, produced by the vaporization of the reboiler feed. Without a source of heat, there can be no vaporization. And without vaporization, there will be no circulation. So we can say that the source of energy that drives the circulation in a thermosyphon reboiler is the heating medium to the reboiler. 

Figure 5.6 shows a once-through forced-circulation reboiler. Such a reboiler differs from a thermosyphon reboiler in that it has a pump to force circulation, rather than rely on natural or thermosyphon circulation. This seems rather wasteful—and it is. 

When considering the steam side of steam heated reboilers, it is best to think about the reboiler as a steam condenser. The steam, at least for a conventional horizontal reboiler, is usually on the tube side of the exchanger, as shown in Fig. 8.1. The steam is on the tube side, because the shell side was selected for the process fluid. If the reboiler is a thermosyphon, or natural-circulation reboiler, then low-process-side pressure drop is important. For a horizontal reboiler, it is easiest to obtain a low pressure drop for the fluid being vaporized by placing it on the shell side. 

Another source of noise is sometimes encountered in columns with thermosyphon reboilers. It has the natural frequency of die manometer between the column base and the reboiler (Figure 11.6). Roughly this is ... 

---