Positive absorption dispersion

The phase-twisted peak shapes (or mixed absorption-dispersion peak shape) is shown in Fig. 3.9. Such peak shapes arise by the overlapping of the absorptive and dispersive contributions in the peak. The center of the peak contains mainly the absorptive component, while as we move away from the center there is an increasing dispersive component. Such mixed phases in peaks reduce the signal-to-noise ratio complicated interference effects can arise when such lines lie close to one another. Overlap between positive regions of two different peaks can mutually reinforce the lines (constructive interference), while overlap between positive and negative lobes can mutually cancel the signals in the region of overlap (destructive interference). 

The antiphase doublet (Fig. 6.14(c)) is dispersive because /-coupling evolution to the antiphase state moves the vectors by 90°, from the +x axis to the +/ and —/ axes. This dispersive antiphase doublet can be phase corrected by moving the reference axis from the +x axis to the +/ axis (90° zero-order phase correction). Now the C = a peak is positive absorptive and the C = ft peak is negative absorptive (Fig. 6.15) and the central 12CH3l peak is pure dispersive because the vector is on the -hx/ axis and the reference axis is now +y (90° phase error). 

Whereas the absorption lineshape is always positive, the dispersion lineshape has positive and negative parts it also extends further. 

Peaks in homonuclear 2D /-resolved spectra have a phase-twisted line shape with equal 2D absorptive and dispersive contributions. If a 45° projection is performed on them, the overlap of positive and negative contributions will mutually cancel and the peaks will disappear. The spectra are therefore presented in the absolute-value mode. 

The addition of finely dispersed solid particles improves the IR absorption of the polymer and positively influences blowing of the preforms. Such solid particles can be obtained by the reduction of Sb3+ to metallic antimony during polycondensation by the addition of trivalent phosphorous compounds such as phosphonic acid or its esters (phosphites). However, only a slight improvement in properties could be achieved by this approach [35],... 

---