Physical quality factors kinetics

The resistance to fluid flow is a measure of the physical structure of the foam. In order to control the flow through a foam, ceU size, degree of reticulation, density, and other physical factors must be controlled. The control of these physical factors, however, is achieved through the chemistry and the process by which the foam is made. The strength of the bulk polymer is measured by the tensile test described above, but it is clear that the tensile strengths of the individual bars and struts that form the boundaries of an individual cell determine, in part, the qualities of the cells that develop. A highly branched or cross-linked polymer molecule will possess certain tensile and elongation properties that define the cells. The process is also a critical part of the fluid flow formula, mostly due to kinetic factors. As discussed above, the addition of a polyol and/or water to a prepolymer initiates reactions that produce CO2 and cause a mass to polymerize. The juxtaposition of these two reactions defines the quality of the foam produced. Temperature is the primary factor that controls these reactions. Another factor is the emulsification of the prepolymer or isocyanate phase with the polyol or water. 

Thus, the basic physical-chemical mechanisms of the volatilization of lead compounds and the factors governing the formation of flash smelting dusts, depending on the quality of the lead feeds treated and the dimensions of the Kivcet unit, are explained on the basis of generalizations and the kinetic analysis of a wide range of experimental data on the production and composition of the Kivcet smelting dust. 

---