Thermospray mass spectrometry

Liquid Chromatography-Mass Spectrometry Thermospray and Atmospheric Pressure Ionization... 

Walhagen A, Edholm L-E, Heeremans GEM et at (1989) Coupled-column chromatography-mass spectrometry. Thermospray liquid chromatographic-mass spectrometric and liquid chromatographic-tandem mass spectrometric analysis of metoprolol enantiomers in plasma using phase-system switching. Journal of Chromatography 474 257. 

See Atmospheric Pressure Ionization in Mass Spectrometry Chemical Ionization in Mass Spectrometry Fast Atom Bombardment Ionization in Mass Spectrometry Ionization Theory, Plasma Desorption Ionization in Mass Spectrometry, Thermospray Ionization in Mass Spectrometry. 

The advent of atmospheric-pressure ionization (API) provided a method of ionizing labile and nonvolatile substances so that they could be examined by mass spectrometry. API has become strongly linked to HPLC as a basis for ionizing the eluant on its way into the mass spectrometer, although it is also used as a stand-alone inlet for introduction of samples. API is important in thermospray, plasmaspray, and electrospray ionization (see Chapters 8 and 11). 

In many applications in mass spectrometry (MS), the sample to be analyzed is present as a solution in a solvent, such as methanol or acetonitrile, or an aqueous one, as with body fluids. The solution may be an effluent from a liquid chromatography (LC) column. In any case, a solution flows into the front end of a mass spectrometer, but before it can provide a mass spectrum, the bulk of the solvent must be removed without losing the sample (solute). If the solvent is not removed, then its vaporization as it enters the ion source would produce a large increase in pressure and stop the spectrometer from working. At the same time that the solvent is removed, the dissolved sample must be retained so that its mass spectrum can be measured. There are several means of effecting this differentiation between carrier solvent and the solute of interest, and thermospray is just one of them. Plasmaspray is a variant of thermospray in which the basic method of solvent removal is the same, but the number of ions obtained is enhanced (see below). 

Aerosols can be produced as a spray of droplets by various means. A good example of a nebulizer is the common household hair spray, which produces fine droplets of a solution of hair lacquer by using a gas to blow the lacquer solution through a fine nozzle so that it emerges as a spray of small droplets. In use, the droplets strike the hair and settle, and the solvent evaporates to leave behind the nonvolatile lacquer. For mass spectrometry, a spray of a solution of analyte can be produced similarly or by a wide variety of other methods, many of which are discussed here. Chapters 8 ( Electrospray Ionization ) and 11 ( Thermospray and Plasmaspray Interfaces ) also contain details of droplet evaporation and formation of ions that are relevant to the discussion in this chapter. Aerosols are also produced by laser ablation for more information on this topic, see Chapters 17 and 18. 

Spectrometric Analysis. Remarkable developments ia mass spectrometry (ms) and nuclear magnetic resonance methods (nmr), eg, secondary ion mass spectrometry (sims), plasma desorption (pd), thermospray (tsp), two or three dimensional nmr, high resolution nmr of soHds, give useful stmcture analysis information (131). Because nmr analysis of or N-labeled amino acids enables determiaation of amino acids without isolation from organic samples, and without destroyiag the sample, amino acid metaboHsm can be dynamically analy2ed (132). Proteia metaboHsm and biosynthesis of many important metaboUtes have been studied by this method. Preparative methods for labeled compounds have been reviewed (133). 

Liquid Ghromatography/Mass Spectrometry. Increased use of Hquid chromatography/mass spectrometry (Ic/ms) for stmctural identification and trace analysis has become apparent. Thermospray Ic/ms has been used to identify by-products in phenyl isocyanate precolumn derivatization reactions (74). Five compounds resulting from the reaction of phenyUsocyanate and the reaction medium were identified two from a reaction between phenyl isocyanate and methanol, two from the reaction between phenyl isocyanate and water, and one from the polymerisation of phenyl isocyanate. There were also two reports of derivatisation to enhance either the response or stmctural information from thermospray Ic/ms for linoleic acid hpoxygenase metabohtes (75) and for cortisol (76). 

One of the reasons for lack offlterature was probably because environmental analysis depends heavily on gas chromatography/mass spectrometry, which is not suitable for most dyes because of their lack of volatility (254). However, significant progress is being made in analyzing nonvolatile dyes by newer mass spectral methods such as fast atom bombardment (EAB), desorption chemical ionization, thermospray ionization, etc. 

The mass spectrometry of diazo compounds was reviewed by Zeller (1983) and by Lebedev (1991). It is difficult to record mass spectra of diazonium salts using conventional techniques. With the water thermospray method, however, Schmelzeisen-Redeker et al. (1985) observed the diazonium ion and various fragments such as [Ar+ - N2 + 2H]+ and [Ar + N2 + H20]+. Ambroz et al. (1988) applied the fast atom bombardment (FAB) technique using a 3-nitrobenzylalcohol matrix. Peaks for ArNJ, Ar+, and [M + ArN2]+ and further peaks due to solvated ions were found. 

For many years, electron ionization, then more usually known as electron impact, was the only ionization method used in analytical mass spectrometry and the spectra encountered showed exclusively the positively charged species produced during this process. Electron ionization also produces negatively charged ions although these are not usually of interest as they have almost no structural significance. Other ionization techniques, such as Cl, FAB, thermospray, electrospray and APCI, however, can be made to yield negative ions which are of analytical utility. 

Electrospray ionization occurs by the same four steps as listed above for thermospray (see Section 4.6). In contrast to thermospray, and most other ionization methods nsed in mass spectrometry, it shonld be noted that electrospray ionization nnnsnally takes place at atmospheric pressure. A similar process carried out under vacuum is known as electrohydrodynamic ionization and gives rise to qnite different analytical results. This technique has not been developed into a commercial LC-MS interface and will not be considered further. 

Barcelo D. 1988. Application of thermospray liquid chromatography/mass spectrometry for determination of organophosphoms pesticides and trialkyl and triaryl phosphates. Biomed Environ Mass Spectrom 17 363-369. 

See footnote cto Table3 LC/PB/MS = hquid chromatography/particle beam mass spectrometry LC/APcl/ESl-MS/MS = liquid chromtography/atmospheric pressure chemical ionization/electrospray ionization tandem mass spectrometry LC/FTIR = Fourier transform infrared LC/TSP-MS/MS = liquid chromatography/thermospray tandem mass spectrometry LC/TSP-MS = liquid chromatography/thermospray mass spectrometry. 

Fast atom bombardment (FAB) Plasma desorption (PD) Liquid secondary-ion mass spectrometry (LSIMS) Thermospray (TSP)/plasmaspray (PSP) Electrohydrodynamic ionisation (EHI) Multiphoton ionisation (MPI) Atmospheric pressure chemical ionisation (APCI) Electrospray ionisation (ESI) Ion spray (ISP) Matrix-assisted laser desorption/ionisation (MALDI) Atmospheric pressure photoionisation (APPI) Triple quadrupole (QQQ) Four sector (EBEB) Hybrid (EBQQ) Hybrid (EB-ToF, Q-ToF) Tandem ToF-ToF Photomultiplier... 

The mass spectra of mixtures are often too complex to be interpreted unambiguously, thus favouring the separation of the components of mixtures before examination by mass spectrometry. Nevertheless, direct polymer/additive mixture analysis has been reported [22,23], which is greatly aided by tandem MS. Coupling of mass spectrometry and a flowing liquid stream involves vaporisation and solvent stripping before introduction of the solute into an ion source for gas-phase ionisation (Section 1.33.2). Widespread LC-MS interfaces are thermospray (TSP), continuous-flow fast atom bombardment (CF-FAB), electrospray (ESP), etc. Also, supercritical fluids have been linked to mass spectrometry (SFE-MS, SFC-MS). A mass spectrometer may have more than one inlet (total inlet systems). 

Figure 6.10 Production of positive ions by thermospray ionisation. After Ashcroft [35]. From A.E. Ashcroft, Ionization Methods in Organic Mass Spectrometry, The Royal Society of Chemistry, Cambridge (1997). Reproduced by permission of The Royal Society of Chemistry...

Simpson, R. C. Fenselau, C. Hardy, M. R. Townsend, R. R. Lee, Y. C. Cotter, R. J. Adaptation of a thermospray liquid chromatography/mass spectrometry interface for use with alkaline exchange liquid chromatography of carbohydrates. Anal. Chem. 1990, 62, 248-252. 

Lant M.S. and Oxford J., 1987. Automated sample preparation online with thermospray high-performance liquid chromatography-mass spectrometry for the determination of drugs in plasma. J Chromatogr A 394 223. 

C. R. Blakley and M. L. Vestal. Thermospray Interface for Liquid Chromatography/Mass Spectrometry. Anal Chem., 55(1983) 750-754. 

P. Arpino. Combined Liquid Chromatography Mass Spectrometry. II. Techniques and Mechanisms of Thermospray. Mass Spectrom. Rev., 9(1990) 631-669. 

This technique is complementary to the thermospray technique. Relative advances of the particles beam technique over thermospray include library searchable electron impact spectra, improved reproducibility, easier use and increased predictability over a broad range of compounds. But since a particle beam requires same sample volatility, very large and polar compounds such as proteins may not provide satisfactory results using particle beam liquid chromatography-mass spectrometry. Additionally, certain classes of compounds such as preformed ions, azo dyes and complex sugars may not yield satisfactory electron impact spectra, but can be run on thermospray. In other words, both liquid chromatography-mass spectrometry techniques complement each other s limitations and the analyst may want to add both to address a broader range of samples. 

---