Macrocyclic compounds alkene metathesis

Since then, the metathesis reaction has been extended to other types of alkenes, viz. substituted alkenes, dienes and polyenes, and to alkynes. Of special interest is the metathesis of cycloalkenes. This gives rise to a ring enlargement resulting in macrocyclic compounds and eventually poly-... 

Dienes are cyclized by intramolecular metathesis. In particular, cyclic alkenes 43 and ethylene are formed by the ring-closing metathesis of the a,co-diene 46. This is the reverse reaction of ethenolysis. Alkene metathesis is reversible, and usually an equilibrium mixture of alkenes is formed. However, the metathesis of a,co-dienes 46 generates ethylene as one product, which can be removed easily from reaction mixtures to afford cyclic compounds 43 nearly quantitatively. This is a most useful reaction, because from not only five to eight membered rings, but also macrocycles can be prepared by RCM under high-dilution conditions. However, it should be noted that RCM is an intramolecular reaction and competitive with acyclic diene metathesis polymerization (ADMET), which is intermolecular to form the polymer 47. In addition, the polymer 47 may be formed by ROMP of the cyclic compounds 43. 

An obvious drawback in RCM-based synthesis of unsaturated macrocyclic natural compounds is the lack of control over the newly formed double bond. The products formed are usually obtained as mixture of ( /Z)-isomers with the (E)-isomer dominating in most cases. The best solution for this problem might be a sequence of RCAM followed by (E)- or (Z)-selective partial reduction. Until now, alkyne metathesis has remained in the shadow of alkene-based metathesis reactions. One of the reasons maybe the lack of commercially available catalysts for this type of reaction. When alkyne metathesis as a new synthetic tool was reviewed in early 1999 [184], there existed only a single report disclosed by Fiirstner s laboratory [185] on the RCAM-based conversion of functionalized diynes to triple-bonded 12- to 28-membered macrocycles with the concomitant expulsion of 2-butyne (cf Fig. 3a). These reactions were catalyzed by Schrock s tungsten-carbyne complex G. Since then, Furstner and coworkers have achieved a series of natural product syntheses, which seem to establish RCAM followed by partial reduction to (Z)- or (E)-cycloalkenes as a useful macrocyclization alternative to RCM. As work up to early 2000, including the development of alternative alkyne metathesis catalysts, is competently covered in Fiirstner s excellent review [2a], we will concentrate here only on the most recent natural product syntheses, which were all achieved by Fiirstner s team. 

Ring-closing metathesis (RCM) of the 6,6 -diallyl ether afforded macrocyclic alkenes,314 which can be reduced (H2/Pd) to saturated compounds with simultaneous removal of all benzyl protecting groups (Scheme 35).68... 

Large-ring products can be accessed readily by ring-closing metathesis. If more than one alkene is present in the substrate then the less-hindered, typically mono-substituted, alkene reacts preferentially. For example, the anticancer epothilone compounds can be prepared by using metathesis as the key ring-forming step. Treatment of the substrate 95 with the catalyst 84 resulted in the formation of both the desired Z-alkene 96 and the E-alkene 97 (2.115). Control of alkene stereochemistry in macrocycle formation is often difficult unless a conformational constraint... 

The epothilones comprise an important set of natural products that were discovered at a time contemporary with the development of ring-closing olefin metathesis. These materials are 16-membered ring compounds containing an alkene in the macrocycle or an epoxide that can be generated from the alkene. A conventional retrosyntlietic analysis... 

---