Tetrahedral lattice

Figure 4.4 Lattice structure of ice created when the maximum number of hydrogen bonds are formed—four per molecule these four hydrogen bonds are arranged in a tetrahedral fashion. This open lattice tetrahedral structure of ice results in ice being less dense than liquid water causing ice to float. (From Stumm and Morgan, 1996, with permission.)...

Zincill) chloride. ZnCl2, is the only important halide—it is prepared by standard methods, but cannot be obtained directly by heating the hydrated salt. It has a crystal lattice in which each zinc is surrounded tetrahedrally by four chloride ions, but the low melting point and solubility in organic solvents indicate some covalent... 

Fig. 8.7 Cubic and tetrahedral (diamond) lattices, which are commonly used for lattice simulations of polymers.

Table 1 Hsts some of the physical properties of duoroboric acid. It is a strong acid in water, equal to most mineral acids in strength and has a p p o of —4.9 as compared to —4.3 for nitric acid (9). The duoroborate ion contains a neady tetrahedral boron atom with almost equidistant B—F bonds in the sohd state. Although lattice effects and hydrogen bonding distort the ion, the average B—F distance is 0.138 nm the F—B—F angles are neady the theoretical 109° (10,11). Raman spectra on molten, ie, Hquid NaBF agree with the symmetrical tetrahedral stmcture (12).

Extensive hydrogen bonding takes place in phosphoric acid solutions. In concentrated (86% H PO solutions, as well as in the crystal stmctures of the anhydrous acid and the hemihydrate, the tetrahedral H PO groups are linked by hydrogen bonding. At lower (75% H PO concentrations, the tetrahedra are hydrogen-bonded to the water lattice. Physical properties of phosphoric acid solutions of various concentrations are Hsted in Table 2 the vapor pressure of aqueous H PO solutions at various temperatures is given in Table 3. 

Properties. Physical properties of titanium tetrachloride are given ia Table 17. la the vapor phase, the titanium tetrachloride molecule is tetrahedral and has a Ti—Cl bond length of 218 pm. The regular tetrahedral coordination is retained ia the soHd, although each of the chlorines is crystaHographicaHy differeat ia the monoclinic lattice (131). 

Fig. 1. Diagrammatic representation of the succession of layers in some layer lattice siHcates (12) where 0 is oxygen , hydroxyl , siHcon o. Si—Al aluminum C, Al—Mg O, potassium , Na—Ca. Sample layers are designated as O, octahedral T, tetrahedral and B/G, bmcite- or gibbsitelike. The...

The higher solubility of carbon in y-iron than in a-iroii is because the face-ceiiued lattice can accommodate carbon atoms in slightly expanded octahedral holes, but the body-centred lattice can only accommodate a much smaller carbon concentration in specially located, distorted tetrahedral holes. It follows that the formation of fenite together with cementite by eutectoid composition of austenite, leads to an increase in volume of the metal with accompanying compressive stresses at die interface between these two phases. 

Fig. 2. Structures for the solid (a) fee Cco, (b) fee MCco, (c) fee M2C60 (d) fee MsCeo, (e) hypothetical bee Ceo, (0 bet M4C60, and two structures for MeCeo (g) bee MeCeo for (M= K, Rb, Cs), and (h) fee MeCeo which is appropriate for M = Na, using the notation of Ref [42]. The notation fee, bee, and bet refer, respectively, to face centered cubic, body centered cubic, and body centered tetragonal structures. The large spheres denote Ceo molecules and the small spheres denote alkali metal ions. For fee M3C60, which has four Ceo molecules per cubic unit cell, the M atoms can either be on octahedral or tetrahedral symmetry sites. Undoped solid Ceo also exhibits the fee crystal structure, but in this case all tetrahedral and octahedral sites are unoccupied. For (g) bcc MeCeo all the M atoms are on distorted tetrahedral sites. For (f) bet M4Ceo, the dopant is also found on distorted tetrahedral sites. For (c) pertaining to small alkali metal ions such as Na, only the tetrahedral sites are occupied. For (h) we see that four Na ions can occupy an octahedral site of this fee lattice.

It may occasion surprise that an amorphous material has well-defined energy bands when it has no lattice planes, but as Street s book points out, the silicon atoms have the same tetrahedral local order as crystalline silicon, with a bond angle variation of (only) about 10% and a much smaller bond length disorder . Recent research indicates that if enough hydrogen is incorporated in a-silicon, it transforms from amorphous to microcrystalline, and that the best properties are achieved just as the material teeters on the edge of this transition. It quite often happens in MSE that materials are at their best when they are close to a state of instability. 

The predominantly ionic alkali metal sulfides M2S (Li, Na, K, Rb, Cs) adopt the antifluorite structure (p. 118) in which each S atom is surrounded by a cube of 8 M and each M by a tetrahedron of S. The alkaline earth sulfides MS (Mg, Ca, Sr, Ba) adopt the NaCl-type 6 6 structure (p. 242) as do many other monosulfides of rather less basic metals (M = Pb, Mn, La, Ce, Pr, Nd, Sm, Eu, Tb, Ho, Th, U, Pu). However, many metals in the later transition element groups show substantial trends to increasing covalency leading either to lower coordination numbers or to layer-lattice structures. Thus MS (Be, Zn, Cd, Hg) adopt the 4 4 zinc blende structure (p. 1210) and ZnS, CdS and MnS also crystallize in the 4 4 wurtzite modification (p. 1210). In both of these structures both M and S are tetrahedrally coordinated, whereas PtS, which also has 4 4... 

Figure 29.1 Crystal structures of ZnS. (a) Zinc blende, consisting of two, interpenetrating, cep lattices of Zn and S atoms displaced with respect to each other so that the atoms of each achieve 4-coordination (Zn-S = 235 pm) by occupying tetrahedral sites of the other lattice. The face-centred cube, characteristic of the cep lattice, can be seen — in this case composed of S atoms, but an extended diagram would reveal the same arrangement of Zn atoms. Note that if all the atoms of this structure were C, the structure would be that of diamond (p. 275). (b) Wurtzite. As with zinc blende, tetrahedral coordination of both Zn and S is achieved (Zn-S = 236 pm) but this time the interpenetrating lattices are hexagonal, rather than cubic, close-packed.

---