Halide saturated vapors

The only parts of Fig. 5 which can meaningfully be described as solubility in a compressed gas are WX and XV. However, a very different situation arises if the saturated vapor pressure curve cuts the critical curve (M—N of Fig. 3). Figure 4 shows that this does not happen for the three sodium halides. The complete course of the critical curve is not known, but enough is known in the case of the sodium chloride system51 75 for it to be clear that it rises well above the maximum of the saturated vapor pressure curve. However, it is cut by the vapor pressure curves of less soluble salts such as sodium carbonate and sodium sulphate.40 87 The (p, T) projection of a system of the type water + sodium chloride is... 

It is now a well-recognized fact that the saturated vapors of alkali halides contain associated species (dimers, trimers, etc.) as well as the diatomic molecules. The first evidence of this behavior was an electron-Impact mass spectrometrlc study by Ionov (] ). He reported the observation of K2I and Na2l" , which he attributed to the process... 

Delepine reaction org chem Slow ammonolysis of alkyl halides in acid to primary amines in the presence of hexamethylenetetramine. del-3,pTn re,ak-sh3n deliquescence phys chem The absorption of atmospheric water vapor by a crystalline solid until the crystal eventually dissolves into a saturated solution. del-3 kwes-3ns ... 

To prepare a titanated catalyst, surface silanol groups on the silica react with a titanium ester or halide. Unreacted organic or halide groups left on the Ti are then replaced by oxide during subsequent calcination. Titanation can be accomplished in various solvents, such as hydrocarbons, alcohols, or even sometimes water, or by vapor-phase deposition. The simplicity of the approach allows any commercial silica to be so modified with up to 5-8 wt% Ti, at which point (depending on the surface area) saturation is reached. Catalyst manufacturers practice titanation but some procedures have also been developed by many polyethylene producers as well. These recipes can be practiced in a commercial polyethylene plant, because the titanium compound is applied as a vapor during the catalyst activation step. 

---