Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Growth stability

S. Mourachov, V. P. Poliakov. Analysis of diamond crystal growth stability from graphite through a film of the metal solvent. Diamond Rel Mater 7 309,... [Pg.925]

This will be elaborated in detail in the following section. However, it is of interest that the existence of concentration-dependent (implying a far-from-equilibrium condition) cross-diffusion terms creates a non-linear mechanism between elements of the system, i.e. the flux of one polymer depends not only on its own concentration gradient but also on that of the other polymer component. This is consistent with two of the criteria required for dissipative structure formation. Furthermore, once a density inversion is initiated, by diffusion, it will be acted upon by gravity (as the system is open ) to produce a structured flow. The continued growth, stability and maintenance of the structures once formed may depend on the lateral diffusion processes between neighbouring structures. [Pg.138]

These examples of crystal studies in the expl field are but a few of many applications that have been reported. Propellants, primers, pyrotechnics many HE s have been greatly improved by the development of processes which control crystal growth stability of the individual fnaterials. Some further info may be found in the Refs listed below. See also Crystallography, Crystals, etc Refs 1)J.R.Johnson, "Crystallographic Studies of RDX, HMX and Related Compounds OSRD Rept 694 (July 1942) 2)J.R.Johnson,... [Pg.351]

In semibatch emulsion polymerizations the polymer particles are kept monomer-starved to obtain higher rates of polymerization and to permit easier control of the rate and particle size distribution. There are two aspects to the control of PSD. The controlled addition of emulsifier during particle growth stabilizes the particles without further particle nucleation. The second aspect is related to the particle sticky stage which often occurs... [Pg.331]

Matrix Particle growth Stability and crack formation Dissolution of y-LiA102 in the electrolyte Phase transformation from y to a variety Changes in the microstructure Increase in the ionic resistivity Decrease in the cell voltage Decrease in the cell life... [Pg.1751]

Ag Alkali increase selectivity, hinder crystal growth, stabilize... [Pg.191]

Seshan, PK., Electrodeposition cells a theoreticed investigation into their performance and deposit growth stability, Ph.D. dissertation, Carnegie-Mellon University, Pittsburgh, Pa., 1975. [Pg.376]

An important measure of economic recovery is the state of business growth, stability, and... [Pg.930]

Multiple. sample capabilities. Plant studies routinely require examination of many. samples, particularly when the objectives of the study include identification of phenotypes with desired growth, stability, or yield characteristics. Screening large populations for individuals with desired metabolic characteristics is impossible in single-sample calorimeters. Current commercial multiwell calorimeters allow up to three samples to be run simultaneously. A calorimeter with as many as 100 sample wells could be effectively employed for plant studies. [Pg.718]


See other pages where Growth stability is mentioned: [Pg.328]    [Pg.8]    [Pg.257]    [Pg.166]    [Pg.119]    [Pg.1899]    [Pg.86]    [Pg.340]    [Pg.96]    [Pg.77]    [Pg.122]    [Pg.360]    [Pg.236]    [Pg.321]    [Pg.44]    [Pg.7]   
See also in sourсe #XX -- [ Pg.134 , Pg.135 , Pg.136 , Pg.137 , Pg.138 ]

See also in sourсe #XX -- [ Pg.264 ]




SEARCH



© 2024 chempedia.info