Geometric phase vector potentials

Finally, in brief, we demonstrate the influence of the upper adiabatic electronic state(s) on the ground state due to the presence of a Cl between two or more than two adiabatic potential energy surfaces. Considering the HLH phase, we present the extended BO equations for a quasi-JT model and for an A -1- B2 type reactive system, that is, the geometric phase (GP) effect has been inhoduced either by including a vector potential in the system Hamiltonian or... 

The relative shift of the peak position of the rotational distiibution in the presence of a vector potential thus confirms the effect of the geometric phase for the D + H2 system displaying conical intersections. The most important aspect of our calculation is that we can also see this effect by using classical mechanics and, with respect to the quantum mechanical calculation, the computer time is almost negligible in our calculation. This observation is important for heavier systems, where the quantum calculations ai e even more troublesome and where the use of classical mechanics is also more justified. 

Figure 2. Quantum classical cross-sections for the reaction D-I-Ha (r — l,j — 1) DH (v — l,/)-l-H at 1.8-eV total energy as a function of /. The solid line indicates results obtained without including the geometric phase effect. Boxes show the results with geometric phase effect included using either a complex phase factor (dashed) or a vector potential (dotted).

As demonstrated in [53] it is convenient to incorporate the geometrical phase effect by adding the vector potential in hyperspherical coordinates. Thus we found that the vector potential gave three terms, the first of which was zero, the second is just a potential term... 

Note that in this TDGH-DVR formulation of quantum dynamics, the inclusion of the geometric phase effects through the addition of a vector potential is veiy simple and the calculations can be carried out with about the same effort as what is involved in the ordinary scattering case. 

As mentioned in the introduction, the simplest way of approximately accounting for the geometric or topological effects of a conical intersection incorporates a phase factor in the nuclear wave function. In this section, we shall consider some specific situations where this approach is used and furthermore give the vector potential that can be derived from the phase factor. 

---