Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Four months after processing

CSF Alls the intracerebral (intraventricular 20%) and extracerebral (subarachnoidal 80%) space. CSF originates from plasma (ultraflltration) as well as from choroid plexus (active secretion) in the ventricles, flows through cisternae and the subarachnoid space, and finally drains through the arachnoid villi into venous blood. Equilition processes establish a physiological ratio between composition and resorption of CSF. CSF flow starts around the time of birth and reaches its maximum rate at four months after birth, following the complete maturation of the arachnoid villi. [Pg.2]

Titanocene chemistry provides an appropriate basis for a discussion of mechanism. Figure 4 shows a recent interpretation of the titanocene fixation-reduction process (13) submitted for publication by the Olives three or four months after our titanocene-N2 paper appeared (II). The mechanism is a complicated one, based essentially on ESR results meas-... [Pg.105]

It should be noted that not all changes have an immediate effect on the process. In some cases, there can be a considerable incubation time before the effects of a change become noticeable. This, of course, complicates the troubleshooting process it is important to keep this in mind and not jump to conclusions. The author experienced a case where a disastrous wear problem was related to an event that took place four months earlier. The wear remained insignificant until about four months after a new feed housing was installed. However, when the rapid wear started, the screw was destroyed within a time period of only 48 hours. [Pg.765]

About four months after beginning the implementation of the action plan, they saw a shift in the mean recordable rate from about 10 to about 4.2. This represents a 68 percent reduction. Another investigator, using our survey and a similar process, saw a reduction in the lost-time rate of over 50 percent (O Toole 2002). [Pg.173]

Approximately four months after the publication of OSHA s proposed standard for process safety management [PSM] of highly hazardous chemicals, the Clean Air Act Amendments (CAAA) were enacted into law (November 15, 1990). Section 304 of the CAAA requires that the Secretary of Labor, in coordination with the... [Pg.65]

The time necessary to recover the function after BoNT paralysis mainly depends on the type of nerve terminal and the type of BoNT. The entire process of recovery from BoNT/A intoxication typically requires two to four months at the mammalian NMJ, but much longer (>1 year) at glands (Naumann and Jost 2004). BoNT/A has been the first type of BoNT used for therapy in humans (Schantz and Johnson 1997 Scott et al. 1989), and luckily it is the one that gives the longest lasting effects. [Pg.152]

NAMAS accreditation is similar to the ISO 9000 certification process, in that it requires a thorough assessment by independently appointed industry experts. Six months following accreditation, a full follow-up visit is made by UKAS, and aimual audits are made thereafter. Four years after accreditation a full re-accreditation assessment is made, although UKAS can make unannounced visits at any time. Laboratories found to be unsatisfactory on inspection will lose NAMAS accreditation until such time as that laboratory again meets the required standard. [Pg.9]

The crevice couples were stuck together at the first examination carried out after 40 days. Other coupons showed normal corrosion. ITie corrosion process was found to be much slower after the first visual examination. However, in February 1997, one crevice couple was removed, and the pH of the solution inside the crevice was determined and found to be 5.5. After about four months, a few nodules were visually detected on some coupons. After six months of exposure, three coupons were removed for destructive examination. They were rinsed in water and acetone, dried, reweighed and then cleaned with 50% phosphoric add. They were again rinsed with water and acetone, dried and reweighed. Weight loss was insignificant even after removal of the oxide. Coupons were then taken for pit measurement. The whole rack was removed on 2000-10-12 and the coupons were photographed, as shown in Fig. 13.1. [Pg.200]


See other pages where Four months after processing is mentioned: [Pg.161]    [Pg.479]    [Pg.27]    [Pg.392]    [Pg.342]    [Pg.294]    [Pg.1119]    [Pg.1123]    [Pg.122]    [Pg.60]    [Pg.542]    [Pg.108]    [Pg.684]    [Pg.157]    [Pg.94]    [Pg.461]    [Pg.97]    [Pg.295]    [Pg.75]    [Pg.202]    [Pg.461]    [Pg.602]    [Pg.1920]    [Pg.155]    [Pg.878]    [Pg.72]    [Pg.44]    [Pg.259]    [Pg.160]    [Pg.602]    [Pg.48]    [Pg.160]    [Pg.1666]    [Pg.375]    [Pg.155]    [Pg.526]    [Pg.270]    [Pg.93]    [Pg.597]    [Pg.431]    [Pg.291]    [Pg.152]   
See also in sourсe #XX -- [ Pg.403 ]




SEARCH



Month

© 2024 chempedia.info