Fluids tensile strength

It is, however, possible to calculate the tensile strength of a liquid by extrapolation of an equation of state for the fluid into the metastable region of negative pressure. Burgess and Everett in their comprehensive test of the tensile strength hypothesis, plot the theoretical curves of T /T against zjp, calculated from the equations of state of van der Waals, Guggenheim, and Berthelot (Fig. 3.24) (7], and are the critical temperature and critical... 

The resistance to fluid flow is a measure of the physical structure of the foam. In order to control the flow through a foam, ceU size, degree of reticulation, density, and other physical factors must be controlled. The control of these physical factors, however, is achieved through the chemistry and the process by which the foam is made. The strength of the bulk polymer is measured by the tensile test described above, but it is clear that the tensile strengths of the individual bars and struts that form the boundaries of an individual cell determine, in part, the qualities of the cells that develop. A highly branched or cross-linked polymer molecule will possess certain tensile and elongation properties that define the cells. The process is also a critical part of the fluid flow formula, mostly due to kinetic factors. As discussed above, the addition of a polyol and/or water to a prepolymer initiates reactions that produce CO2 and cause a mass to polymerize. The juxtaposition of these two reactions defines the quality of the foam produced. Temperature is the primary factor that controls these reactions. Another factor is the emulsification of the prepolymer or isocyanate phase with the polyol or water. 

S. = maximum cross-sectional area of plummet, ft2 Ss = safe working stress, lbf/in.2 ST = tensile strength, lbf/in.2 t = minimum wall thickness, in., see Table 4 T = temperature, °R u = internal energy, ft lbf/lbm v = specific volume of fluid, ft3/lbm... 

---