Fluid catalytic cracking catalyst regeneration

The MTO process employs a turbulent fluid-bed reactor system and typical conversions exceed 99.9%. The coked catalyst is continuously withdrawn from the reactor and burned in a regenerator. Coke yield and catalyst circulation are an order of magnitude lower than in fluid catalytic cracking (FCC). The MTO process was first scaled up in a 0.64 m /d (4 bbl/d) pilot plant and a successfiil 15.9 m /d (100 bbl/d) demonstration plant was operated in Germany with U.S. and German government support. 

The most dominant catalytic process in the United States is the fluid catalytic cracking process. In this process, partially vaporized medium-cut petroleum fractions called gas oils are brought in contact with a hot, moving, freshly regenerated catalyst stream for a short period of time at process conditions noted above. Spent catalyst moves continuously into a regenerator where deposited coke on the catalyst is burnt off. The hot, freshly regenerated catalyst moves back to the reactor to contact the hot gas oil (see Catalysts, regeneration). 

Catalytic Pyrolysis. This should not be confused with fluid catalytic cracking, which is used in petroleum refining (see Catalysts, regeneration). Catalytic pyrolysis is aimed at producing primarily ethylene. There are many patents and research articles covering the last 20 years (84—89). Catalytic research until 1988 has been summarized (86). Almost all catalysts produce higher amounts of CO and CO2 than normally obtained with conventional pyrolysis. This indicates that the water gas reaction is also very active with these catalysts, and usually this leads to some deterioration of the olefin yield. Significant amounts of coke have been found in these catalysts, and thus there is a further reduction in olefin yield with on-stream time. Most of these catalysts are based on low surface area alumina catalysts (86). A notable exception is the catalyst developed in the former USSR (89). This catalyst primarily contains vanadium as the active material on pumice (89), and is claimed to produce low levels of carbon oxides. 

Chen Junwu, Cao Hanchang, and Liu Taiji, Catalyst Regeneration in Fluid Catalytic Cracking Volume 21... 

CATALYSTS - REGENERATION - FLUID CATALYTIC CRACKING UNITS] (Vol5)... 

Indicated in Fig. 2 is a representative fluid catalytic cracking unit, comprising ( )a reactor (2) a regenerator (3) the main fractionator (4) an air blower or compressor (3) a spent-catalyst stripper (6) catalyst recovery equipment, including cyclones internal in the reactor and regenerator and slurry settler, and possibly an electrostatic precipitator and (7) a gas-recovery unit. The catalyst used is essentially u specially prepared composite of silica and alumina. 

---