Fiber mechanical strength

Reinforcing Fiber Mechanical Strength Electrical Properties Impact Resistance Corrosion Resistance Machining and Punching Heat Resistance Moisture Resistance Abrasion Resistance Low Cost Stiffness... 

Hoshii and Kojima [191] prepared three types of diphenylborosilane (PBS), an organometallie eompound with Si—O—B bonds, using different Si/B molar ratios and compounded with carbon fiber. Mechanical strength of the composites so formed increased with an increase of Si content in the PBS. When a PBS with a high B content was used, a compact vitreous film of B2O3 was formed over the composite, improving the oxidation resistance of the composite. 

Nonoxide fibers, such as carbides, nitrides, and carbons, are produced by high temperature chemical processes that often result in fiber lengths shorter than those of oxide fibers. Mechanical properties such as high elastic modulus and tensile strength of these materials make them excellent as reinforcements for plastics, glass, metals, and ceramics. Because these products oxidize at high temperatures, they are primarily suited for use in vacuum or inert atmospheres, but may also be used for relatively short exposures in oxidizing atmospheres above 1000°C. 

These cylinder units are applicable to almost any form of sheet material that is not injuriously affected by contact with steam-heated metal surfaces. They are used chiefly when the sheet possesses certain properties such as a tendency to shrink or lacks the mechanical strength necessary for most types of continuous-sheeting air diyers. Applications are to diy films of various sorts, paper pulp in sheet form, paper sheets, paperboard, textile piece goods and fibers, etc. In some cases, imparting a special finish to the surface of the sheet may be an objective. 

Glass Ceramic fibers and particles Mechanical strength Temperature resistance Chemical resistance Thermal stability... 

Organics, Carbon, glass, organic fibers, glass Mechanical strength... 

The decrease in the fiber diameter of fabric resulted in a decrease in porosity and pore size, but an increase in fiber density and mechanical strength. The microfiber fabric made of PCLA (1 1 mole ratio) was elastomeric with a low Young s modulus and an almost linear stress-strain relationship under the maximal stain (500%) in this measurement. 

---