Electronic states spectra

SXES spectroscopy [111] ejects K electrons and the spectrum of the resulting x-rays is measured Spectroscopy of Emitted Electrons state of adsorbed molecules surface composition... 

XPS X-ray photoelectron spectroscopy [131-137] Monoenergetic x-rays eject electrons from various atomic levels the electron energy spectrum is measured Surface composition, oxidation state... 

Figure Al.6.13. (a) Potential energy curves for two electronic states. The vibrational wavefunctions of the excited electronic state and for the lowest level of the ground electronic state are shown superimposed, (b) Stick spectrum representing the Franck-Condon factors (the square of overlap integral) between the vibrational wavefiinction of the ground electronic state and the vibrational wavefiinctions of the excited electronic state (adapted from [3]).

Now the spectrum will show various transitions originating with state iih and ending on the various vibrational levels la of the lower electronic state. Equation (Bl.1.14) (or Bl.1.13) if we have to worry about variation of transition... 

An interesting example occurs in the spectrum of the C2 molecule. The usual rule of absorption spectroscopy is that the transitions originate in the ground electronic state because only it has sufficient population. However, in C2 transitions were observed starting both from a fl state and from a jTstate, so it was not... 

Figure Bl.6.11 Electron transmission spectrum of 1,3-cyclohexadiene presented as the derivative of transmitted electron current as a fiinction of the incident electron energy [17]. The prominent resonances correspond to electron capture into the two unoccupied, antibonding a -orbitals. The negative ion state is sufficiently long lived that discrete vibronic components can be resolved.

This teclnhque can be used both to pennit the spectroscopic detection of molecules, such as H2 and HCl, whose first electronic transition lies in the vacuum ultraviolet spectral region, for which laser excitation is possible but inconvenient [ ], or molecules such as CH that do not fluoresce. With 2-photon excitation, the required wavelengdis are in the ultraviolet, conveniently generated by frequency-doubled dye lasers, rather than 1-photon excitation in the vacuum ultraviolet. Figure B2.3.17 displays 2 + 1 REMPI spectra of the HCl and DCl products, both in their v = 0 vibrational levels, from the Cl + (CHg) CD reaction [ ]. For some electronic states of HCl/DCl, both parent and fragment ions are produced, and the spectrum in figure B2.3.17 for the DCl product was recorded by monitoring mass 2 (D ions. In this case, both isotopomers (D Cl and D Cl) are detected. 

Figure 3. Low-energy vibronic spectrum in a. 11 electronic state of a linear triatomic molecule, computed for various values of the Renner parameter e and spin-orbit constant Aso (in cm ). The spectrum shown in the center of figure (e = —0.17, A o = —37cm ) corresponds to the A TT state of NCN [28,29]. The zero on the energy scale represents the minimum of the potential energy surface. Solid lines A = 0 vibronic levels dashed lines K = levels dash-dotted lines K = 1 levels dotted lines = 3 levels. Spin-vibronic levels are denoted by the value of the corresponding quantum number P P = Af - - E note that E is in this case spin quantum number),...

Figure 5, Low-eriergy vibronic spectrum in a electronic state of a linear triatomic molecule. The parameter c determines the magnitude of splitting of adiabatic bending potential curves, is the spin-orbit coupling constant, which is assumed to be positive. The zero on the...

Vo + V2 and = Vo — 2 (actually, effective operators acting onto functions of p and < )), conesponding to the zeroth-order vibronic functions of the form cos(0 —4>) and sin(0 —(()), respectively. PL-H computed the vibronic spectrum of NH2 by carrying out some additional transformations (they found it to be convenient to take the unperturbed situation to be one in which the bending potential coincided with that of the upper electi onic state, which was supposed to be linear) and simplifications (the potential curve for the lower adiabatic electi onic state was assumed to be of quartic order in p, the vibronic wave functions for the upper electronic state were assumed to be represented by sums and differences of pairs of the basis functions with the same quantum number u and / = A) to keep the problem tiactable by means of simple perturbation... 

The peak in the UV VIS spectrum of acetone [(CH3)2C=0] corresponding to the transition appears at 279 nm when hexane is the solvent but shifts to 262 nm in water Which is more polar the ground electronic state or the excited stated... 

In HyperChem, you can now compute the energy difference between the ground electronic state and the first few excited electronic states of a molecular system by using the ab initio method or any of the semi-empirical methods except for the Extended Hiickel. To generate a UV-vis spectrum, you must perform a singly excited Cl method with the ab initio method or semi-empirical method you choose. 

We can use the energy level diagram in Figure 10.14 to explain an absorbance spectrum. The thick lines labeled Eq and Ei represent the analyte s ground (lowest) electronic state and its first electronic excited state. Superimposed on each electronic energy level is a series of lines representing vibrational energy levels. 

By obtaining values for B in various vibrational states within the ground electronic state (usually from an emission spectrum) or an excited electronic state (usually from an absorption spectrum) the vibration-rotation interaction constant a and, more importantly, B may be obtained, from Equation (7.92), for that electronic state. From B the value of for that state easily follows. 

Figure 9.18 shows a typical energy level diagram of a dye molecule including the lowest electronic states Sq, and S2 in the singlet manifold and and T2 in the triplet manifold. Associated with each of these states are vibrational and rotational sub-levels broadened to such an extent in the liquid that they form a continuum. As a result the absorption spectrum, such as that in Figure 9.17, is typical of a liquid phase spectrum showing almost no structure within the band system. 

Figure 9.50 Processes involved in obtaining (a) an ultraviolet photoelectron spectrum, (b) a zero kinetic energy photoelectron (ZEKE-PE) spectrum by a one-photon process and (c) a ZEKE-PE spectrum by a two-photon process in which the first photon is resonant with an excited electronic state of the molecule...

Figure 9.51 A zero kinetic energy photoelectron (ZEKE-PE) resonant two-photon spectrum of 1,4-difluorobenzene in which the first photon excites the molecule of the zero-point level of the S-[ excited electronic state of the molecule. (Reproduced, with permission, from Reiser, G., Rieger, D., Wright, T.G., Muller-Dethlefs, K. and Schlag, E.W., J. Phys. Chem., 97, 4335, 1993)...

Pfleiderer has suggested that the 7-hydroxy group exists as such in these compounds because this form is stabilized by mesomerism of type 191 (R — H). The tautomerism of 7-hydroxypteridine-2,4-dione in the excited electronic state has been studied on the basis of its fluorescence spectrum. 

---