Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Dioxane, acid-base parameter

B. l,3>2>Dioxaphospholens.—The kinetics of the addition of trialkyl phosphites to benzil have been investigated spectrophotometrically. The second-order reaction of trimethyl phosphite in dioxan has activation parameters of A// = 8.4 kcal mol and AS = — 47.5 e.u. In benzene the rate constant increases linearly with low concentrations of added organic acid and decreases linearly with low concentrations of added base. The Diels-Alder mechanism is considered unlikely on the basis of these data, and the slow step is considered to be nucleophilic addition of the phosphite to the carbon of the carbonyl group (see Scheme). [Pg.34]

Hydration of several 1,2,3-triones including indane derivatives (70 Scheme 4) has been studied in dioxane-water mixtures.1053 Monohydration gives a 2,2-diol (71) forward rates and equilibrium constants have been measured over a wide range of solvent composition. Based on activation parameters, kinetic isotope effects, a Hammett treatment, and a second-order rate dependence on water, two water molecules are suggested to play distinct roles, one as nucleophile, the other as general acid-base, similar to dialdehydes.105b,c... [Pg.19]

Typical normal-phase operations involved combinations of alcohols and hexane or heptane. In many cases, the addition of small amounts (< 0.1 %) of acid and/or base is necessary to improve peak efficiency and selectivity. Usually, the concentration of polar solvents such as alcohol determines the retention and selectivity (Fig. 2-18). Since flow rate has no impact on selectivity (see Fig. 2-11), the most productive flow rate was determined to be 2 mL miiT. Ethanol normally gives the best efficiency and resolution with reasonable back-pressures. It has been reported that halogenated solvents have also been used successfully on these stationary phases as well as acetonitrile, dioxane and methyl tert-butyl ether, or combinations of the these. The optimization parameters under three different mobile phase modes on glycopeptide CSPs are summarized in Table 2-7. [Pg.52]

Kinetics of the acid hydrolysis of A-alkenyl derivatives of phenoxazine, phenoth-iazine, and carbazole in aqueous dioxane suggest an ASe2 mechanism, based on the activation parameters and isotope effects. ... [Pg.29]

The apparent acid dissociation constants (p s)Ka) of two water-insoluble drugs, ibuprofen and quinine, were determined pH-metrically in ACN water, dimethyl-formamide water, DMSO water, 1,4-dioxane-water, ethanol water, ethylene glycol-water, methanol water, and tetrahydrofuran water mixtures. A glass electrode calibration procedure based on a four-parameter equation (pH = alpha-i- SpcH -i-jH[H+] -i-jOH[OH ]) was used to obtain pH readings based on the concentration scale (pcH). We have called this four-parameter method the Four-Plus technique. The Yasuda Shedlovsky extrapolation p s)K a + log [H2O] = A/epsllon -1- B) was used to derive acid dissociation constants in aqueous solution (pKa). It has been demonstrated that the pK a values extrapolated from such solvent-water mixtures are consistent with each other and with previously reported measurements. The suggested method has also been applied with success to determine the pKa values of two pyridine derivatives of pharmaceutical Interest. Spectrometric, ultraviolet (UV) ... [Pg.138]


See other pages where Dioxane, acid-base parameter is mentioned: [Pg.93]    [Pg.180]    [Pg.874]    [Pg.110]    [Pg.113]    [Pg.621]    [Pg.180]    [Pg.2144]    [Pg.357]    [Pg.535]   
See also in sourсe #XX -- [ Pg.73 ]




SEARCH



Acids parameters

© 2024 chempedia.info