Dimethylsiloxane comonomer

Styrene monomer was also copolymerized with a series of functional monomers by using a single-step dispersion copolymerization procedure carried out in ethanol as the dispersion medium by using azobisizobu-tyronitrile and polyvinylpyrollidone as the initiator and the stabilizer, respectively [84]. The comonomers were methyl methacrylate, hydroxyethyl acrylate, metha-crylic acid, acrylamide, allyltrietoxyl silane, vinyl poly-dimethylsiloxane, vinylsilacrown, and dimethylamino-... 

Narrow distribution in the backbone length as well as in the chemical composition or the branch frequency may be expected from a living-type copolymerization between a macromonomer and a comonomer provided the reactivity ratios are close to unity. This appears to have been accomplished to some extent with anionic copolymerizations with MMA of methacrylate-ended PMMA, 29, and poly(dimethylsiloxane) macromonomers, 30, which were prepared by living GTP and anionic polymerization, respectively [50,51]. Recent application [8] of nitroxide (TEMPO)-mediated living free radical process to copolymerizations of styrene with some macromonomers such as PE-acrylate, la, PEO-methacr-ylate, 27b, polylactide-methacrylate, 28, and poly(e-caprolactone)-methacrylate, 31, may be a promising approach to this end. 

The pyrolysate of polyacrylic-/nfer-nef-polysiloxane copolymer contains as main fragment molecules pyrolysis products similar to those of poly(butyl acrylate) and of poly(dimethylsiloxane (see Figure 6.7.8. and Section 16.1). The identification of fragments that would indicate sequences of other comonomers or any molecular connections between the two types of comonomer units was not possible. Other copolymers with acrylic acid as comonomer were studied using analytical pyrolysis. Among these are copolymers with special properties such as the copolymer with the formula shown below ... 

Therefore, once the type of modifier is selected, e.g. a statistical copolymer of acrylonitrile and butadiene, its miscibility with the monomers may be varied significantly by changing the nature of end-groups, the fraction of both comonomers in the copolymer, and the molar mass distribution. The same trends have been observed with rubbers based on n-butyl acrylate [73] or dimethylsiloxane [74]. The introduction of acrylonitrile units, polycaprolactone blocks [75], or phenyl groups in the modifiers increases the polarity and the initial miscibility in polar monomers like epoxy resins or bismaleimides [76]. 

---