Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Designer, duties

VENDOR SHALL STATE THE REQUIREO FLOWS. PRESSURE DROPS AND DESIGN DUTIES FOR EACH JACKET. STILL CONDENSER, AND FREEZEOUTTRAP. [Pg.697]

Please observe in your program run that you have lost 6% of your exchange design duty ... [Pg.175]

Design duties and basis of calculation of all relief valves, rupture disks, etc. [Pg.31]

All personnel (permanent, contractors, consultants, and temporary staff) developing, supporting, or using a GxP computer system must be trained so that they acquire the necessary level of competency before they may be allowed to perform their designated duties. To this end, all personnel involved in any aspect of validation should have ... [Pg.71]

VENDOR SHALLSTATETHE required flows, pressure drops ano design DUTIES for each jacket, still CONDENSER, AND freezeouttrap. [Pg.698]

Actual working conditions (dusty smroundings, outdoor installation) and deviations from design duty conditions,... [Pg.334]

Equipment Design Duty 1010tph (wet) vs 1023tph actual equip capacity... [Pg.503]

Surge Storage at Loading Station Surge Bin 3.5 Hrs live at design duty production rate... [Pg.503]

Design duty conditions (flow, temperature, pH, pressure)... [Pg.15]

The above data should be updated every month. An analysis of the data will enable the plant management to decide about replacement of particular equipment. However, one should closely look into the differences, if atty, between the design duty conditions and the actual conditions in which the unit is operated. It may be possible to trace the reasons of equipment failure in these conditions. Hence, suitable changes may be made in the specifications while procuring replacements. [Pg.15]

The variation in discharge temperature is 6.8°F. For an air cooler cooling the compressed gas to 120°F, this results in a design duty variation up to 3.5% depending on which correlation is chosen. [Pg.299]

Designers duties are mostly covered by Regulation 13 of CDM. The extent of any liability of designers had previously been a grey area within the terms of the Health and... [Pg.71]

It is appropriate to set out here the CDM designer duties. Designers must ... [Pg.72]

Q should be calculated, For heat exchanger, its design duty can be used for conservative liquid relief estimation. B is cubical expansion coefficient per degree Fahrenheit It can be calculated by following equation ... [Pg.153]

See other pages where Designer, duties is mentioned: [Pg.111]    [Pg.767]    [Pg.750]    [Pg.560]    [Pg.2]    [Pg.747]    [Pg.2]    [Pg.113]    [Pg.912]    [Pg.714]    [Pg.714]    [Pg.158]    [Pg.560]    [Pg.392]    [Pg.1189]    [Pg.121]    [Pg.185]    [Pg.348]    [Pg.406]    [Pg.407]    [Pg.363]    [Pg.519]    [Pg.18]    [Pg.69]    [Pg.72]    [Pg.262]    [Pg.69]    [Pg.69]    [Pg.299]    [Pg.67]    [Pg.10]    [Pg.25]    [Pg.27]    [Pg.28]   
See also in sourсe #XX -- [ Pg.72 ]



SEARCH



Duty/duties

© 2024 chempedia.info