Dehydrogenation catalyst libraries

Array microreactors and mass spectrometry were used to find the best composition of Pt-Pd-Ir for the dehydrogenation of cyclohexane to benzene.210,211 A catalyst library of 37 binary alloys composed of transition metals, Cu, Zn, and Ti or Si, was screened by IR thermography in the hydrogenation of 1-hexyne, and the oxidation of isooctane and toluene.212... 

Combinatorial methods were also applied in the discovery of new catalysts for the low-temperature oxidation213 and oxidative dehydrogenation of propane.214 A 144-member catalyst library was screened by photothermal deflection spectroscopy and mass spectrometry to find the most active compositions of V-Al-Nb and Cr-Al-Nb oxides for the oxidative dehydrogenation of ethane.215 The ternary combination V(45)-Sn(45)-Mo(10)-O selected by laser-induced fluorescence imaging gave much higher yield than did V205 in the selective oxidation of naphthalene to naphthoquinone.216... 

Figure 3.35 Ethylene produced by oxidative dehydrogenation of ethane over Mo-V-Nb and Ni-Ce-Ta oxide catalyst libraries. The detection of ethylene was performed in a scanning mass spectrometer using a photothermal deflection method. Inactive Mo-V-Nb oxide catalyst (a) active Ni-Ce-Ta oxide library (b) [7] (by courtesy of Kluwer Academic Publishers).

Senkan and Ozturk (52) reported the synthesis and screening of a 66-member discrete heterogeneous catalyst library L7, containing Pt, Pd, and In, for the dehydrogenation of cyclohexane to benzene at 300 °C. The structure of L7 and its synthesis are reported in Fig. 11.8. Sixty-six jxrrous alumina pellets (30 mg each) were shaped into 0.3-cm-diameter, 0.1-cm-high cylinders (step a), then immersed in aqueous HCl solutions containing the 66 appropriate mixtures of InCh, PdCli, and HiPtCle (step... 

Primary screening can be done on wafer-based ternary mixed metal oxide libraries. For the oxidative dehydrogenation of ethane, two interesting libraries consist of Ni-Ce-Nb and Ni-Ce-Ta oxides. The maximum amount of ethylene produced is 1800 ppm at 400 °C in nickel-rich regions of the catalyst mixture (Figure 3.35b) compared with inactive Mo-V-Nb oxide catalysts (Figure 3.35a) [7]. 

---