3- Cyanopropyl

C, decomposes slowly into cyanopropyl radicals and is useful for initiation of radical reactions. 

This experiment describes a quantitative analysis for the active ingredients in a prescription antipsychotic medication. The separation makes use of a cyanopropyl derivatized column and a mobile phase of 70% v/v acetonitrile, 5% v/v methanol, and 25% v/v 0.1 M aqueous KH2PO4. A UV detector set to 215 nm is used to measure the eluent s absorbance. 

In discussing mechanism (5.F) in the last chapter we noted that the entrapment of two reactive species in the same solvent cage may be considered a transition state in the reaction of these species. Reactions such as the thermal homolysis of peroxides and azo compounds result in the formation of two radicals already trapped together in a cage that promotes direct recombination, as with the 2-cyanopropyl radicals from 2,2 -azobisisobutyronitrile (AIBN),... 

Figure 3.4 Two-dimensional separation of dimethylnaphthalenes in crude oil using a 50 m methyl (95%)/phenyl (5%) polysiloxane primary column and a 50 m methyl (50%)/phenyl (25%)/cyanopropyl (25%) polysiloxane secondary column. The top trace indicates the primary separation monitor, while the following chromatograms indicate individual heart-cut secondary analysis. Reproduced from R.G. Schafer and J. Holtkemerr, Anal. Chim. Acta. 1992, 260, 107 (20).

Nickel in the presence of ammonia is often used for reduction of nitriles to primary amines. The reaction is done at elevated temperatures and pressures ( 100 C, 1000 psig) unless massive amounts of nickel are used. Cobalt is used similarly but mainly under even more vigorous conditions. Nitriles containing a benzylamine can be reduced over Raney nickel to an amine without hydrogenolysis of the benzyl group (7). A solution of butoxycarbonyl)-3-aminopropyl]-N-<3-cyanopropyl)benzylamine (13.6 g) in 100 ml of ethanol containing 4 g. NaOH was reduced over 3.0 g Raney nickel at 40 psig for 28 h. The yield of A/ -benzyl-Air -(f-butoxycarbonyl)s >ermidine was 95% (7). 

A mixture of 84 parts of 3,3-diphenyl-3-cyanopropyl bromide, 41 parts of 4-piperidino4-pi-peridinecarboxamide, 64 parts of sodium carbonate, a small amount of potassium iodide and 1,200 parts of anhydrous toluene was stirred, and heated under reflux for 48 hours. At the end of this time the reaction mixture was allowed to cool to room temperature, and 500 parts of water were added. The resultant precipitate was removed by filtration, and triturated with diisopropyl ether. The crystalline material thus obtained was removed by filtration, and re-crystalli2ed from 320 parts of acetone, to give 1 -(3,3-diphenyl-3-cyanopropyl)4-piperidino-4-piperidinecarboxamide, melting at about 149°C to 150°C. 

The most commonly used siloxane modifiers are those having phenyl, trifluoro-propyl and cyanopropyl substituents. Introduction of phenyl units into the polydimethylsiloxane backbone either in the form of methylphenylsiloxane or diphenyl-siloxane increases the thermal and oxidative stability, glass transition temperature and the organic solubility characteristics of the resulting copolymers. At low levels (5-10 percent by weight) of incorporation, bulky phenyl groups also break up the regularity of polydimethylsiloxane chains and inhibit the crystallization (Tc... 

Certain heteroatom-substituted aliphatic phosphites have also been employed in these sequences, depending on their stability. Generally, phosphites bearing a-substituents led to higher yields than were obtained with phosphites having p-subsdtuents (27). For example, bis-p-cyanoethyl phosphite gave a relatively modest yield (-25%) of coupled triester product (34,35), whereas a very good yield (83%) of desired product was isolated ftom reactions with bis-a-cyanopropyl phosphite (36). 

Haliclonacyclamine E (13) and arenosclerins A (14), B (15), and C (16) have been isolated from the marine sponge Arenosclera brasiliensis, endemic in Brazil. Crude extracts of this sponge displayed potent cytotoxic and antibiotic activities, and were subjected to fractionation by sihca-gel flash chromatography, medium pressure chromatography on a SiOH cyanopropyl-bonded column, and reversed-phase Cis column chromatography to give compounds 13-16 [18]. The structure elucidation was based on spectroscopic analysis, including HRFABMS, COSY, HSQC, HSQC-TOCSY, and HMBC NMR... 

Haliclonacyclamine F (25), arenosclerin D (26), and arenosclerin E (27) have been recently isolated from the sponge Pachychalina alcaloidifera endemic in Brazil [26]. The alkaloids 25-27 were isolated from the cytotoxic, antibiotic, and antituberculosis MeOH crude extract of P. alcaloidifera by a series of separations on silica-gel and cyanopropyl-bonded silica-gel columns. The structures of compounds 25-27 were established by the same approach employed for the structural elucidation of haliclonacyclamine E (13) and arenosclerins A-C (14-16) [18], as well as by comparison with NMR data for this last series of alkaloids. The alkaloids 25-27 displayed moderate cytotoxic activity against SF295 (human CNS), MDA-MB435 (human breast), HCT8 (colon), and HL60 (leukemia) cancer cell lines. 

Figure 2.6 Reagents used for the deactivation of silanol groups on glass surfaces. A - disilazanes, B > cyclic siloxanes, and C -silicon hydride polysiloxanes in which R is usually methyl, phenyl, 3,3,3-trifluoropropyl, 3-cyanopropyl, or some combination of these groups. The lover portion of the figure provides a view of the surface of fused silica with adsorbed water (D), fused silica surface after deactivation with a trimethylsilylating reagent (E), and fused silica surface after treatment with a silicon hydride polysiloxane (F).

---