Conical guide

The position of the floating element can be observed directly, if the conical guide tube consists of glass or quartz. If that is not possible, then its position can also be measured magnetically, if it contains a magnet and the pipe consists of a nonmagnetic material. 

The design of the mold is usually divided into two parts. The two shaping plates are centered by a conical guide. Typically, a mold has up to 100 cavities, which can be compressed at once. 

Commonly, it is asserted that upward transitions from the lower adiabat to the upper one should be less likely than downward transitions because of the funneling property of the intersection [144,145]. This is clearly seen in the usual model conical intersection—as seen, for example, in Fig. 1 of Ref. 146, where there is (a) a well, or funnel, in the upper adiabat which guides the wavepacket to the intersection and (b) a peak on the lower adiabat which tends to guide the wavepacket away from the intersection. The potential energy surfaces shown in Fig. 7 differ from this canonical picture, and in particular it is not at all clear that the wavepacket on the lower adiabatic state will be funneled away from the intersection. For the conditions chosen in our calculations, we... 

E. T. J. Nibbering, P. F. Curley, G. Grillon, B. S. Prade, M. A. Franco, F. Salin, A. Mysyrowicz, Conical emission from self-guided femtosecond pulses in air, Optics Letters 21, 62 (1996). 

Fig. 1.6. Beam directioning during soft-landing the focusing octopole ion guide. The schematics present a 3D view of the newly constructed conical octopole guide. Eight rods shaped as truncated cone (diameter rejuvenates from 3 to 0.5 mm) are arranged in a conical geometry. Two Teflon plates at the ends with four carriage bolts and two metal collars (in the cylindrical part) keep the conical geometry. The ion entrance orifice opens 9 mm in iimer diameter and the exit focuses to around 2-mm spot size [74]...

Since the relative position and height of the neighbouring elements after immersion and until after the filling out of gaps beneath the tube floor had been, in the region of the joints, determined solely by the conical automatic guiding of the coupling sockets (Fig.8) position... 

Rear guide pad Is below d/2, normal pre-drilling conditions, small hole diameters, low tendency to jamming even for tools with small conicity... 

The purpose of center drilling is to drift a conical hole that will serve as a centering guide in a subsequent machining operation. Center drilling is typically performed using a drill with... 

A second method is the iso-conic partitioning method (Nan Wang 2008) that resembles the isophote method, but it generates isolines, called equi-space contour lines, on a surface that refer to small variation of the machine rotary axes. Figure 17 shows curves that are equidistant in regard of machine rotations. Similar, these isolines are not tool path curves, but some of them can be used as guide ways for tool paths. 

Figure 10.33 Kamitsu conical roller traverse guide for self threading and fiber quality. Source Courtesy of Izumi International Inc., CA, USA.

These findings open the possibility to control the final product yield and the reaction rate by guiding the wavepacket selectively through one of the conical intersections. Thus the analysis of the reaction mechanism allows us to define intermediate control objectives in contrast to taking a... 

---