Steric configuration

No cases of cis/trans isomerism have yet been reported among organo-cobalt(III) complexes, even among compounds not covered by this review. Complexes such as [R2Co(bipy)2] all have the cis configuration steric hindrance would be greatly increased by the coplanarity of the two bipyridyl ligands in the trans isomer 123). 

Colloidal suspensions are often stabilized by the adsorption of polymers that are expected to exert additional configurational-steric repulsive forces. The additional, potentially significant van der Waals interactions between polymer coatings... 

Spatial configuration (steric orientation of negative charges)... 

The only isolable complex is the tris(C2H4.)3Ni formulation. The D31, planar configuration sterically impedes addition of a fourth C2H4 ligand, which would yield an 18-electron complex. 

Figure 8.3 Synthesis of modular fenchyl phosphinites (FENOPs) and directed attack of nucleophiles trans to phosphorus In palladium phosphinooxazolines allyl complexes (electronic differentiation) with exo or endo configuration (steric differentiation) [317, 318]. (Reproduced with permission from Ref [317].)...

The asymmetrical reduction of carbonyl compounds by BY constitutes one of the most widely applicable reactions. Thus, ketones with varying aUcyl/aryl substituents are reduced by yeasts [32-35] and the secondary alcohols obtained were mainly of (S) configuration. Sterically hindered ketones are not reduced at all. From these findings a hydrogen transfer... 

For so-called steric stabilization to be effective, tire polymer needs to be attached to tire particles at a sufficiently high surface coverage and a good solvent for tire polymer needs to be used. Under such conditions, a fairly dense polymer bmsh witli tliickness L will be present around the particles. Wlren two particles approach, such tliat r < d + 2L, tire polymer layers may be compressed from tlieir equilibrium configuration, tluis causing a repulsive interaction. 

For acyclic fragments and molecules, the principle of longest pathways has been implemented in CORINA (sec Figure 2-95) i.e., since no ch configuration is specified, all torsions arc set to anti in order to minimize steric interactions. 

Furthermore, the catalytic allylation of malonate with optically active (S)-( )-3-acetoxy-l-phenyl-1-butene (4) yields the (S)-( )-malonates 7 and 8 in a ratio of 92 8. Thus overall retention is observed in the catalytic reaction[23]. The intermediate complex 6 is formed by inversion. Then in the catalytic reaction of (5 )-(Z)-3-acetoxy-l-phenyl-l-butene (9) with malonate, the oxidative addition generates the complex 10, which has the sterically disfavored anti form. Then the n-a ir rearrangement (rotation) of the complex 10 moves the Pd from front to the rear side to give the favored syn complex 6, which has the same configuration as that from the (5 )-( )-acetate 4. Finally the (S)-( )-mal-onates 7 and 8 are obtained in a ratio of 90 10. Thus the reaction of (Z)-acetate 9 proceeds by inversion, n-a-ir rearrangement and inversion of configuration accompanied by Z to isomerization[24]. 

Tacticity of products. Most solid catalysts produce isotactic products. This is probably because of the highly orienting effect of the solid surface, as noted in item (1). The preferred isotactic configuration produced at these surfaces is largely governed by steric and electrostatic interactions between the monomer and the ligands of the transition metal. Syndiotacticity is mostly produced by soluble catalysts. Syndiotactic polymerizations are carried out at low temperatures, and even the catalyst must be prepared at low temperatures otherwise specificity is lost. With polar monomers syndiotacticity is also promoted by polar reaction media. Apparently the polar solvent molecules compete with monomer for coordination sites, and thus indicate more loosely coordinated reactive species. 

Fig. 2. The steric protection of the carbon backbone by fluorine of a polytetrafluoroethylene chain. The hehcal configuration with a repeat distance of 1.68...

These reactions can be cataly2ed by bases, eg, pyridine, or by Lewis acids, eg, 2inc chloride. In the case of asymmetric alcohols, steric control, ie, inversion, racemi2ation, or retention of configuration at the reaction site, can be achieved by the choice of reaction conditions (173,174). Some alcohols dehydrate to olefins when treated with thionyl chloride and pyridine. 

CyclooctatetraenylCompounds. Sandwich-type complexes of cyclooctatetraene (COT), CgH g, are well known. The chemistry of thorium—COT complexes is similar to that of its Cp analogues in steric number and electronic configurations. Thorocene [12702-09-9], COT2Th, (16), the simplest of the COT derivatives, has been prepared by the interaction of ThCl [10026-08-1] and two equivalents of K CgHg. Thorocene derivatives with alkyl-, sdyl-, and aryl-substituted COT ligands have also been described. These compounds are thermally stable, air-sensitive, and appear to have substantial ionic character. 

The configuration at the chiral centers C-4a, C-5a, and C-12a determine the conformation of the molecule. In order to retain optimum in vitro and in vivo activity, these centers must retain the natural configuration. The hydrophobic part of the molecule from C-5 to C-9 is open to modification ia many ways without losing antibacterial activity. However, modification at C-9 may be critical because steric iateractions or hydrogen bonding with the oxygen atom at C-10 may be detrimental to the activity. 

The neutral complexes of chromium, molybdenum, tungsten, and vanadium are six-coordinate and the CO molecules are arranged about the metal in an octahedral configuration as shown in stmcture (3). Vanadium carbonyl possesses an unpaired electron and would be expected to form a metal—metal bond. Steric hindrance may prevent dimerization. The other hexacarbonyls are diamagnetic. 

The copper(I) ion, electronic stmcture [Ar]3t/ , is diamagnetic and colorless. Certain compounds such as cuprous oxide [1317-39-1] or cuprous sulfide [22205-45 ] are iatensely colored, however, because of metal-to-ligand charge-transfer bands. Copper(I) is isoelectronic with ziac(II) and has similar stereochemistry. The preferred configuration is tetrahedral. Liaear and trigonal planar stmctures are not uncommon, ia part because the stereochemistry about the metal is determined by steric as well as electronic requirements of the ligands (see Coordination compounds). 

---