Bingham plastic fluids scale

For non-Newtonian liquids and suspensions, an apparent viscosity is determined using correlations which include power input and the Reynolds number. Scale-up comparisons based on heat generation data only were determined by comparison of results from RC1 experiments and from a 675-liter reactor [208]. In the experiments, a Bingham plastic fluid was used to determine the film heat transfer coefficient. This presents a worst case because of the low thermal conductivity of the Bingham plastic. Calculated inside film heat transfer coefficients determined in the RC1 tests were about 60% lower than the values determined in the pilot plant reactor, even though substantial effort was made to obtain both geometric and kinematic similarity in the pilot reactor. 

One simple rheological model that is often used to describe the behavior of foams is that of a Bingham plastic. This appHes for flows over length scales sufficiently large that the foam can be reasonably considered as a continuous medium. The Bingham plastic model combines the properties of a yield stress like that of a soHd with the viscous flow of a Hquid. In simple Newtonian fluids, the shear stress T is proportional to the strain rate y, with the constant of proportionaHty being the fluid viscosity. In Bingham plastics, by contrast, the relation between stress and strain rate is r = where is... 

Figure 3.30. Shear stress-shear rate data for Bingham-plastic and false-body fluids using linear scale axes...

Etchells AW, Ford WN, Short DGR. Mixing of Bingham plastics on an industrial scale. In Fluid Mixing III, Symposium Series 108, Institution of Chemical Engineers. Rugby, UK Hemisphere Publ. Corp., 1985 271-285. 

---