Beaded doubler panel

The first type of bonded design for this application was the beaded doubler panel (Fig. 28). This design was fairly successful at addressing the problems with simple riveted structure but had two primary drawbacks. The area under the beads remained a single thickness sheet and was still prone to fatigue. Reducing the unbonded areas under the beads was not a solution because it reduced the overall stiffness of the panel. Secondly, tooling for these panels was complex and not very robust. Autoclave pressure applied to the beaded areas of the doubler would cause them to collapse, so thick frames were fabricated with cutouts for the beads to protect them. A rubber layer bonded to the surface of the frames... 

---

See also in sourсe #XX -- [ ]

See also in sourсe #XX -- [ ]

---