Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Average shear strength

The average shear strength at the interface, t., whether bonded, debonded or if the surrounding matrix material is yielded, whichever occurs first, can be approximately estimated from a simple force balance equation for a constant interface shear stress (Kelly and Tyson, 1965) ... [Pg.47]

Press Average Shear Strength Resin1 Temperature Dry Wet2 Boil3 (°C) (MPa) (MPa) (MPa)... [Pg.373]

Determination of Fibre-Matrix Adhesion. The average shear strength x and maximum shear strength Xmax at the fibre-matrix interface CZ, 22) are given by... [Pg.198]

Average shear strength, 5-percentile shear strength and average wood failure of the PF adhesive bonds with regard to the method of preparation of the specimens prior to testing... [Pg.228]

AWF = average wood failure (%), 5-perc. strength = average shear strength (MPa). [Pg.228]

The highest shear strength of the PF adhesive bond was observed for the untreated control specimens, where the average shear strength was 8.55 MPa. The lowest average shear strength of 4.92 MPa was observed for the most heat-treated specimens bonded with PF adhesive. A similar decrease in the shear strength of the adhesive bond, due to heat treatment, was previously found [15, 33, 34]. [Pg.228]

The shear strength of the PF adhesive bond after pretreatment 2 decreased in comparison with the previous pretreatment. This was expected due to the greater severity of pretreatment 2. However, within the scope of this pretreatment, the average shear strength was almost the same for all the groups of specimens (around 3.7 MPa), except for the most severely treated sample (HT-8.66), whose shear strength was significantly lower (3.1 MPa). [Pg.229]

Pull-out test In this test, the force to pull a single filament out of a resin block or a micro droplet is determined. The average shear strength r, can be related to the embedded length le. ... [Pg.174]

A conventional approach to assess a slope s stability is to consider the relationship between the capacity C that is the average shear strength of the soil and the demand D that is the shear stress developed along the potential failure surface. The relation can be expressed by a factor of safety as the follow ... [Pg.260]

The average shear strength of epoxy adhesive with different MWCNT weight fraction (Hsiao et al. 2003)... [Pg.307]

See other pages where Average shear strength is mentioned: [Pg.253]    [Pg.253]    [Pg.189]    [Pg.145]    [Pg.193]    [Pg.207]    [Pg.253]    [Pg.657]    [Pg.256]    [Pg.380]    [Pg.260]    [Pg.416]    [Pg.418]    [Pg.622]    [Pg.259]    [Pg.264]    [Pg.99]    [Pg.2749]   
See also in sourсe #XX -- [ Pg.198 , Pg.199 ]



SEARCH



Shear strength

Shearing strength

© 2024 chempedia.info