Allylic electrophiles, substitution with

In contrast to allyl halides substituted with one ASG, the cyclopropanation reaction proceeds relatively smoothly when a second ASG is present. Generally, the best results are obtained with sodium borohydride, sodium cyanide, potassium cyanide, and the sodium salts of alcohols or thiols as the nucleophilic species (Table 22, entries 3-26). Even spiroalkanes can be synthesized with the nucleophiles described above (Table 23). Examples illustrating this route are the conversion of a tetracyclic enamino ester with potassium cyanide to the corresponding electrophilic cyclopropane 2, and the facile one-pot synthesis of 1,1 -bis(hydroxymethyl)cyclo-propanes 3 by reduction of halogenated alkylidene malonates with lithium aluminium hydride.  

The scope of allylic electrophiles that react with amines was shown to encompass electron-neutral and electron-rich ciimamyl methyl carbonates, as well as furan-2-yl and alkyl-substituted allylic methyl carbonates. An ort/io-substituted cinnamyl carbonate was found to react with lower enantioselectivity, a trend that has been observed in later studies of reactions with other nucleophiles. The electron-poor p-nitrocinnamyl carbonate also reacted, but with reduced enantioselectivity. Allylic amination of dienyl carbonates also occur in some cases with high selectivity for formation of the product with the amino group at the y-position over the s-position of the pentadienyl unit [66]. Arylamines did not react with allylic carbonates under these conditions. However, they have been shown to react in the presence of the metalacyclic iridium-phosphoramidite catalysts that are discussed in Sect. 4. 

Pyrrolo[3,2-f]pyridine can be readily substituted with a variety of electrophiles at C-2 or C-3 after protection of the ring nitrogen atom. Derivatives can be synthesized with substituents such as iodo, methyl, trimethyltin, formyl, and allyl groups. The reactions proceed with excellent yields (47-95%) <200583581 >. 

The scope of reaction has been further extended to allylic electrophiles. An extensive investigation of the intramolecular acylpalladation has been performed in a series of < -iodoalkenylbenzenes with both terminal and internal double bonds and 1-iodo-substituted 1,4-, 1,5-, or 1,6-dienes.  

This reaction, for which the term prototropic rearrangement is sometimes used, is an example of electrophilic substitution with accompanying allylic rearrangement. The mechanism involves abstraction by the base to give a resonance-stabilized carbanion, which then combines with a proton at the position that will give the more stable olefin 56 

Cyclic epoxides such as 124 can react in two ways with strong bases (a) via abstraction of a /3-proton to form allylic alcoholates 125 or (b) by deprotonation at the epoxide carbon atom forming the intermediate 126 and, after electrophilic substitution, the epoxides 128. If there is a suitable C—H bond in the vicinity of the C-Li moiety, intramolecular carbenoid insertion reactions to 127 may take place (equation 27) ° .  

Phenolic derivatives were prepared and then converted into thioether analogs using ethanedithol followed by oxidation of this intermediate to the disulfide. Phenolic resins were prepared by electrophilic substitution of allyl phenol derivatives with formaldehyde and then flee radically copolymerizing with ethanedithol. Epoxidation was performed using epichlarohydrine. 

Allyl esters, carbonates, and carbamates readily undergo C-O bond cleavage upon reaction with palladium(O) to yield allyl palladium(II) complexes. These complexes are electrophilic and can react with nucleophiles to form products of allylic nucleophilic substitution. Linkers based on this reaction have been designed, which are cleavable by treatment with catalytic amounts of palladium complexes [165,166], For the immobilization of carboxylic acids, support-bound allyl alcohols have proven suitable (Figure 3.12, Table 3.7). 

Modes of cycloaddition of alkylideneallyl cation are also controlled by the reaction conditions. [4 + 3] Cycloaddition occurs in the reaction with furan. The [4 + 3] cycloaddition with furan was observed for the siloxy-substituted allyl cation 5S, but not for the methoxy-substituted allyl cation 5M. The lower electrophilicity of 5S may prefer the concerted pathway of [4 + 3] cycloaddition in competition with the stepwise pathway to yield a [3 + 2] cycloadduct and an electrophilic substitution product. 

Molecular orbitals demonstrate the smooth transition from the allyl silane, which has a k bond and a C-Si O bond, to the allylic product with a new K bond and a new o bond to the electrophile. The intermediate cation is mainly stabilized by O donation from the C-Si bond into the vacant p orbital but it has other a-donating groups (C—H, C-C, and C-E) that also help. The overall process is electrophilic substitution with allylic rearrangement. Both the site of attachment of the electrophile and the position of the new double bond are dictated by the silicon. 

In basic aqueous media, a kinetic study of the reaction between stannate(II) ions and alkyl halide shows that mono- and disubstituted organotin compounds are formed (Eq. 6.12a).27 The monosubstituted organotin compound is obtained after a nucleophilic substitution catalyzed by a complexation between the tin(II) and the halide atom. The disubstituted compound results from an electrophilic substitution coupled with a redox reaction on a complex between the monosubstituted organotin compound and the stannate(II) ion. Stannate(IV) ions prevent the synthesis of the disubstituted compound by complexation. Similarly, when allyl bromide and tin were stirred in D2O at 60° C, allyltin(II) bromide was formed first. This was followed by further reaction with another molecule of allyl bromide to give diallyltin(IV) dibromide (Eq. 6.12b).28 

---